Emerson FA-700 Installation And Operation Manual

Emerson FA-700 Installation And Operation Manual

Freezealarm dialer
Table of Contents
FreezeAlarm Dialer
FA-700
Installation and Operations Manual
Emerson Control Products Inc.
1724 Lake Drive West
Chanhassen, MN 55317
Document No. 42420079B
Table of Contents
loading

Summary of Contents for Emerson FA-700

  • Page 1 FreezeAlarm Dialer FA-700 Installation and Operations Manual Emerson Control Products Inc. 1724 Lake Drive West Chanhassen, MN 55317 Document No. 42420079B...
  • Page 2: Table Of Contents

    ........13 LEDs ............5 An in-phone line answering Operation............. 6 machine/voice mail with the FA-700 . 13 FA-700 normal operation ......6 How this works ......14 How the FA-700 receives power ....6 Calling the FA-700 during an alarm Alarm operation ........
  • Page 3 For easy future reference during technical support and service, it is recommended that you write your purchase date, date code, and serial number of the device in the spaces below. The “date code” can be found on the label affixed to the bottom of the FA-700. URCHASE DATE...
  • Page 4: Cautions And Warnings

    • Do not throw batteries into a fire. Failure to observe this warning could result in an explosion. • Do not install or connect the FA-700 to power or phone line during a lightning storm. Failure to observe this warning could result in an electrical shock.
  • Page 5: Description

    Connects the FA-700 to the wall phone jack, length 7ft (2.1m). General description The FA-700 monitors your home for a variety of alarm conditions. When an alarm event occurs, the FA-700 calls the programmed phone number for the following alarms: •...
  • Page 6: Operation

    • Monitors the AA backup batteries for low power. How the FA-700 receives power The FA-700 receives power from a 6-volt AC power adapter (included) and two AA batteries (not included) that supply back-up power during an AC power failure.
  • Page 7: Dip Switch Functions And Settings

    The FA-700 has a 4-position DIP switch. The switch settings determine how the FA-700 will respond to specific alarm conditions. Figure 2 shows the DIP switch and Table 3 explains the functions of each switch. Turn the FA-700 upside down as shown in Figure 2 for proper DIP switch orientation.
  • Page 8: Power Up Sequence

    If the back-up battery voltage drops below 2.35 volts, a low battery alarm will be sent, even when the unit is powered by the AC power adapter. The FA-700 will call the programmed phone number and issue a low battery alarm message. If the unit is operating on battery power only (after an AC power failure), the alarm call-out will continue until battery power drops to approximately 1.9 volts.
  • Page 9: Installing The Batteries

    Installing the batteries Note: To avoid a false low battery alarm, please connect the AC power adapter to the FA-700 and the wall outlet before inserting batteries. To install the batteries, follow the Steps shown in Figure 4. Figure 4: Battery Installation Connections...
  • Page 10: Connecting The Fa-700 And Another Device To The Same Phone Jack

    DO NOT WORK. Those phone services require that power be on at the location for the phone to operate. The FA-700 will NOT be able to call out if the power is out when using these phone services. If you have a standard telephone line, power is supplied to this line by the telephone company and is usually not affected when power goes out at the monitored location.
  • Page 11: Calls Using A Calling Card Or Pager Phone Number

    Creating pauses You can add pauses to your telephone number as you enter it into the FA-700 by pressing the STAR (*) key two times, which represents a 2-second pause. If you need to enter a 6-second pause, press the STAR (*) key six times.
  • Page 12: Changing The Call-To Phone Number

    Figure 6 shows an example of an ideal setup. Place the FA-700 on any flat surface, preferably a table top near an AC Power outlet and a phone jack as shown in Figure 6. Once the FA-700 is fully assembled and operational (power LED ON), perform a phone test to ensure that the FA-700 can call the call-to phone number during an alarm.
  • Page 13: Testing Your Fa-700

    When it is necessary to connect an answering machine or voice mail device to the same phone line as the FA-700, you can still use all the features of these devices, along with being able to cancel an alarm call out of the FA-700.
  • Page 14: How This Works

    • Set your answering machine or voice mail to answer in fewer rings than the FA-700. (For example, if the FA-700 is set to answer on 5 rings, set the other device to answer in “4” or fewer rings.) Therefore, when a call comes into the location of the FA-700, the answering machine/voice mail will respond first because it is set to answer in fewer rings than the FA-700.
  • Page 15: Canceling An Alarm Call-Out By Calling The Fa-700

    Press the pound (#) key anytime during the message to cancel the alarm call out. Hang up the phone. Remote status information During normal operation, the FA-700 will not answer any incoming calls. You can call the FA-700 and get a response: • If the FA-700 is in alarm.
  • Page 16: Troubleshooting

    • If you are using a phone calling card, check to see that the calling sequence includes pauses as may be necessary to complete the call. • The FA-700 will not answer if there is no active alarm FA-700 does not answer when I call event in progress.
  • Page 17: Technical Information

    RENs, contact your local telephone company. The REN for this product is 0.1B and is also identified as part of the FCC product identifier shown on the label on the back of your FA-700. Telephone network interferences If this FA-700 causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required.
  • Page 18: Contact Us

    Warrantor: Dealer, Distributor, Retailer, Manufacturer Warranty and remedy We believe the FA-700 is a superior product. Although we take extreme pride in producing and testing a product that will function properly, we cannot guarantee that there will never be a defective unit or that a unit will function on all the thousands of phone lines and communication equipment in existence.
  • Page 19: Warrantors' Liability

    How to request an RGA number To request a RGA #, call Emerson at 800-880-6000 and ask for Customer Service. Failure to have a RGA # may result in lost product or significant delays in handling your return. Also, products...

This manual is also suitable for:

Homesitter hs-700

Table of Contents