Hard Drive Cage (Rear); Removing The Rear Hard Drive Cage - Dell EMC PowerEdge R640 Installation And Service Manual
Hide thumbs
Also See for EMC PowerEdge R640:
- Manual (49 pages) ,
- Hardware installation manual (2 pages) ,
- Installation and service manual (175 pages)
Table of Contents
Figure 89. Cable routing - 8 x 2.5 hard drive backplane with onboard SATA
1
hard drive backplane
3
backplane signal cable
5
system board
7
cable routing clip
Hard drive cage (rear)
The hard drive cage supports up to two 2.5 inch hard drives.
Removing the rear hard drive cage
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove all the hard drives.
4
Disconnect all the cables from the rear hard drive backplane.
Steps
1
Using Phillips #2 screwdriver, loosen the screw that secures the hard drive cage to the system.
2
Pull and hold the screw to lift the hard drive cage away from the system.
134
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
Safety
instructions.
Before working inside your
2
cable routing clip
4
backplane power cable
6
SATA cable
system.
- Quick Links:
- Front View of the System
Hide quick links:
Table of Contents
