Chapter 3 Electrical Installation 3.1 Wiring Of Power Cable Table 3-1 Max. steady state AC and DC currents...
Page 34
Table 3-2 Recommended CSA of the UPS cable (unit: mm , ambient temperature: 25°C) Table 3-3 Selection of the UPS I/O switch Table 3-4 Min. distance between UPS connection point and floor...
3.2 Wiring Of Signal Cable Figure 3-7 Illustration drawing of communication box ports Figure 3-8 Input dry contact ports J1 and J5...
Page 43
Table 3-5 Description of input dry contact ports J1 and J5 Figure 3-9 BCB port J2 Table 3-6 Description of BCB port J2...
Page 44
UPS inside External ports Figure 3-10 Backfeed protection dry contact port J3 Table 3-7 Description of backfeed protection dry contact port J3 Figure 3-11 Remote EPO input port J4 Table 3-8 Description of remote EPO input port J4...
Page 45
Table 3-9 Pins definition of RS485 communication port Figure 3-12 Cable connection diagram of RS485 communication port Chapter 8 Options Table 3-10 Models and installation positions of optional cards...
Chapter 4 Operator Control And Display Panel 4.1 Introduction Figure 4-1 Operator control and display panel Table 4-1 Description of components of the operator control and display panel Table 4-2 Definition of indicators...
Page 49
Table 4-3 Description of audible alarm Table 4-4 Description of control keys Table 4-5 Description of menu keys ×...
4.2 LCD Screen Type Figure 4-2 Start screen NXC 60kVA 16:21:17 A (AB) B (BC) C (CA) L-N voltage (V) L-N current (V) 20.5 20.5 20.5 Frequency (HZ) 50.1 50.1 50.1 L-L voltage (V) 0.99 0.99 0.99 Power factor OutPut Figure 4-3 Primary screen...
6.4 Precautions For Installation Design 6.5 Battery Installation Environment And Number Of Batteries Table 6-1 Ambient temperature range ° ° ° ° ° ° °...
6.10 BCB Reference Current And Connection Table 6-6 BCB rated current and battery max. discharge current at full load (recommended) Figure 6-5 Connections between the battery, BCB and UPS 6.11 Battery Maintenance...
Page 99
5.6.1 Procedures For Completely Powering Down UPS 7.3.5 Procedures For Completely Powering Down UPS Figure 8-11 Connection between UF-RS485 card and battery temperature sensor Figure 8-12 DIP switch of temperature sensor...
Page 100
Figure 8-13 Installation and connection of battery temperature sensor Table 8-4 Dimensions of the seismic anchor kits × ×...
Page 101
Remove the adjustable feet Adjustable foot (4 pcs) Adjustable foot (4 pcs) Figure 8-14 Removing adjustable feet × Figure 8-15 Installing seismic anchor 1 and seismic anchor 2 × Figure 8-16 Installing seismic anchor 3 Figure 8-17 Fixing seismic anchor 4 on the ground and fixing the cabinet ×...
Chapter 9 Communication 9.1 SNMP Protocol Communication Liebert IntelliSlot Web Card Quick Start Guide 9.2 Modbus Protocol Communication Liebert IntelliSlot Modbus 485, Modbus IP And BACnet IP Reference Guide 9.3 Dry Contact Communication Liebert IntelliSlot Relay Card User Manual...
Chapter 10 Service And Maintenance 10.1 Safety 10.2 Key Components And Service Life Of UPS Table 10-1 Life parameters and the proposed replacement time of key components...