H1 Board; H2 Board - Sony FWD-40LX1 Service Manual
Hide thumbs
Also See for FWD-40LX1:
- Operating instructions manual (316 pages) ,
- Specifications (2 pages) ,
- Protocol manual (24 pages)
Table of Contents
1-4-6. H1 Board
Removal
1. Remove the cabinet assembly. (Refer to Section 1-3-1.)
2. Remove the two screws (BVST3 x 6), then remove
the control button panel.
3. Remove the three screws (BVTP3 x 8), then remove
the H1 board.
4. Disconnect the harness from the connector (CN9100)
on the H1 board.
BVST
3 x 6
Control button
panel
H1 board
Conductive cushion
Installation
5. Reinstall the H1 board in the reverse order of steps 2
to 4.
n
When attaching the control panel assembly, route the
harness through the opening.
6. Reattach the cabinet assembly. (Refer to Section 1-3-1.)
FWD-40LX1
Opening
Control panel assembly
Harness
Control button
CN9100
Harness
BVTP
3 x 8
1-4-7. H2 Board
Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the bezel assembly. (Refer to Section 1-3-2.)
3. Remove the hook from the rib in the center of the
lower portion on the bezel assembly.
4. Slowly incline the H2 board in the direction of the
arrow, then remove it from the bezel assembly.
H2 board
Hook (upper portion)
Openings
Rib
Installation
5. Reinstall the H2 board in the reverse order of steps 3
and 4.
n
When installing the H2 board, insert the two hooks
(upper portion) into the openings of the cabinet
assembly and push in the hook (lower portion).
6. Reassemble this unit in the reverse order of steps 1 and 2.
Hook (upper portion)
Hook
(lower portion)
CN9200
Bezel assembly
Conductive cushion
Bezel
assembly
H2 board
1-9
Table of Contents
