Operating Range Of The Remote Control Unit - Pioneer KRP-500A Operating Instructions Manual
Flat screen tv
Hide thumbs
Also See for KRP-500A:
- Brochure & specs (28 pages) ,
- Brochure (83 pages) ,
- Operating instructions manual (339 pages)
Table of Contents
Available languages
Available languages
05
Preparation
Operating range of the remote control unit
Operate the remote control unit while pointing it toward the remote
control sensor located at the bottom right of the front panel of the
display. The distance from the remote control sensor must be
within 7 m and the angle relative to the sensor must be within 30
degrees in the right, left, upward, or downward direction.
Note
• For remote control sensor locations, see Part names on
page 12.
Caution
• Do not expose the remote control unit to shock. In addition, do
not expose the remote control unit to liquids, and do not place
in an area with high humidity.
• Do not install or place the remote control unit under direct
sunlight. The heat may cause deformation of the unit.
• The remote control unit may not work properly if the remote
control sensor of the flat screen TV is under direct sunlight or
strong lighting. In such case, change the angle of the lighting
or display, or operate the remote control unit closer to the
remote control sensor.
• When any obstacle exists between the remote control unit and
the remote control sensor, the remote control unit may not
function.
• As the batteries become empty, the remote control unit can
function within a shorter distance from the remote control
sensor. Replace the batteries with new ones early enough.
• The display emits very weak infrared rays from its screen. If you
place such equipment operated through infrared remote
control as a VCR nearby, that equipment may not receive
commands from its remote control unit properly or entirely. If
this is the case, place that equipment at a location far enough
from the display.
• Depending on the installation environment, infrared rays from
the display may not allow this system to properly receive
commands from the remote control unit or may shorten
allowable distances between the remote control unit and the
remote control sensor. The strength of infrared rays emitted
from the screen differs, depending on images displayed on the
screen.
20
En
7 m
30º
30º
Remote
control
sensor
- Quick Links:
- Media Receiver
- Basic Connections
- Specifications
Hide quick links:
Chapters
Table of Contents
