Toshiba e-STUDIO206L Service Manual page 1016
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO206L:
- Troubleshooting manual (132 pages) ,
- Quick start manual (90 pages) ,
- User manual (42 pages)
Table of Contents
(9)
When the update is completed normally, the LED on the download jig starts blinking.
The LED on the download jig starts blinking approx. 20 seconds after the update started. It is
assumed that the update has failed if the LED does not start blinking even after 30 seconds have
elapsed. In this case, shut down the equipment and check the following items. Then clear the
problems and restart updating from the beginning.
•
Is the downloading jig connected properly?
•
Is the ROM attached to the downloading jig properly?
•
Is the DIP-SW4 on the hole punch control PC board set properly?
•
Has the update data been written correctly to the ROM on the jig?
•
Is the download jig or the equipment damaged?
•
Is the connector (CN12) on the finisher control PC board connected properly?
•
Are the connector (CN15) on the finisher control PC board and the connector (CN1) on the
hole punch control PC board connected properly?
(10) Press the [ON/OFF] button on the control panel and turn the power OFF using the main power
switch and remove the download jig.
(11) Set the DIP-SW4 on the hole punch control PC board to OFF.
Notes:
When the number of blinks is other than "6" (which indicates that the adjustment value is "0") at
the section "[A]Checking the hole punch position", follow the steps of "5.1 Stopping Position
Adjustment" in the MJ-6103 Service Manual to adjust the value to the one that has been set
before the update.
(12) Change the settings of the DIP-SW1 and -SW2 on the hole punch control PC board according to
the model as shown in the figure below.
(13) Install the rear cover of the hole punch unit.
(14) Install the rear lower cover of the hole punch unit.
(15) Install the finisher board access cover.
[C] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P. 11-81 "11.7 Confirmation of the updated data"
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
FIRMWARE UPDATING
MJ-6103E
ON
1
2
3
4
MJ-6103F
ON
1
2
3
4
Fig.11-56
11 - 60
MJ-6103N
ON
1
2
3
4
MJ-6103S
ON
1
2
3
4
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
- Quick Links:
- Service Manual
Hide quick links:
Table of Contents
Troubleshooting
