Precautions For Cordless Jig Saw; Caution On Lithium-Ion Battery - Hitachi CJ 14DSL Handling Instructions Manual
Hide thumbs
Also See for CJ 14DSL:
- Handling instructions manual (100 pages) ,
- Technical data and service manual (27 pages) ,
- Instruction manual (64 pages)
Table of Contents
English
CAUTION
Keep children and infi rm persons away.
When not in use, tools should be stored out of reach of children and infi rm persons.
PRECAUTIONS FOR CORDLESS JIG SAW
1.
Always charge the battery at a temperature of 0 – 40°C.
A temperature of less than 0°C will result in over charging which is dangerous. The
battery cannot be charged at a temperature greater than 40°C.
The most suitable temperature for charging is that of 20 – 25°C.
2.
When one charging is completed, leave the charger for about 15 minutes before
the next charging of battery.
3.
Do not allow foreign matter to enter the hole for connecting the rechargeable
battery.
4.
Never disassemble the rechargeable battery and charger.
5.
Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause a great electric current and overheat. It
results in burn or damage to the battery.
6.
Do not dispose of the battery in fi re.
If the battery burnt, it may explode.
7.
Do not insert object into the air ventilation slots of the charger.
Inserting metal objects or infl ammables into the charger air ventilation slots will
result in electrical shock hazard or damaged charger.
8.
Bring the battery to the shop from which it was purchased as soon as the post-
charging battery life becomes too short for practical use. Do not dispose of the
exhausted battery.
9.
Using an exhausted battery will damage the charger.
10. If the machine is used continuously at low speed, an extra load is applied to the
motor which can result in motor seizure. Always operate the power tool so that
the blade is not caught by the material during operation. Always adjust the blade
speed to enable smooth cutting.
CAUTION ON LITHIUM-ION BATTERY
To extend the lifetime, the lithium-ion battery equips with the protection function to stop
the output.
In the cases of 1 and 2 described below, when using this product, even if you are pulling
the switch, the motor may stop. This is not the trouble but the result of protection
function.
1.
When the battery power remaining runs out, the motor stops.
In such case, charge it up immediately.
2.
If the tool is overloaded, the motor may stop. In this case, release the switch of tool
and eliminate causes of overloading. After that, you can use it again.
Furthermore, please heed the following warning and caution.
24
Chapters
Table of Contents
