Stp Instance Settings - D-Link xStack DGS-3600 User Manual
Layer 3 gigabit ethernet managed switch
Hide thumbs
Also See for xStack DGS-3600:
- User manual (433 pages) ,
- Cli manual (431 pages) ,
- Hardware installation manual (66 pages)
Table of Contents
Parameter
Instance ID
Internal cost
(0=Auto)
Priority
Click Apply to implement changes made.
STP Instance Settings
The following window displays MSTIs currently set on the Switch. To view the following table, click L2 Features > Spanning
Tree > STP Instance Settings:
The following information is displayed:
Parameter
Description
Instance Type
Displays the instance type(s) currently configured on the Switch. Each instance type is classified
by a MSTI ID. CIST refers to the default MSTI configuration set on the Switch.
Instance Status
Displays the current status of the corresponding MSTI ID
Displays the priority of the corresponding MSTI ID. The lowest priority will be the root bridge.
Instance Priority
Click Apply to implement changes made.
Click the Modify button to change the priority of the MSTI. This will open the Instance ID Settings window to configure.
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch
Description
Displays the MSTI ID of the instance being configured. An entry of 0 in this field denotes the
CIST (default MSTI).
This parameter is set to represent the relative cost of forwarding packets to specified ports
when an interface is selected within a STP instance. The default setting is 0 (auto). There are
two options:
0 (auto) - Selecting this parameter for the internalCost will set quickest route
•
automatically and optimally for an interface. The default value is derived from the
media speed of the interface.
value 1-200000000 - Selecting this parameter with a value in the range of 1-
•
200000000 will set the quickest route when a loop occurs. A lower Internal cost
represents a quicker transmission.
Enter a value between 0 and 240 to set the priority for the port interface. A higher priority will
designate the interface to forward packets first. A lower number denotes a higher priority.
Figure 7- 34. STP Instance Table window
Figure 7- 35. STP Instance Settings - modify priority window
104
Table of Contents
