Table of Contents
KV-DR29M93
RM-991
1-6. SERVICE POSITION ON TV STAND
Note: 1) Remove the Rear Cover (refer 1-1)
- unscrew all 14 screws fixed on the Rear Cover. Hold
the top of the TV Cabinet; lift the Rear Cover slightly
upwards to release the Rear Cover foot from the TV
Stand and slide it backwards from the TV Cabinet.
2) Remove the 3D Speaker Box (refer 1-2)
3) Release the Lead Assy Speaker (left side)
4) Lift up the chassis and place it in the Service
Position as shown:-
Caution: 1) In Service Position, make
sure all the TV connections
are connected correctly
before turning on the TV
set.
2) The TV on the TV Stand
without Rear Cover is
unstable. As such be
careful not to push the TV
foward or backward
1-7. TERMINAL BRACKET REMOVAL
3 One screw
(+BVTP 3 × 12)
1-9. F1 BOARD REMOVAL
Place the front of the main
bracket on to the foot of the
TV Cabinet
3 One screw
(+BVTP 3 × 12)
5 Terminal bracket
2 Two screws
(+BVTP 3 × 12)
1 One screw
(+BVTP 4 × 16)
4 Two hooks
2 F1 Board
1 Two hooks
1-8. B3 AND D5 BOARDS REMOVAL
Note: Access to the B3 board is possible after removal
of the shiledcase. Remove the shiledcase by
removing 2 screws +BVTP 3x16
1 Two clips
1-10. BC1 AND P BOARDS REMOVAL
2 BC1 Board
– 8 –
Use a non elastic and non
conductive string to tie the
main bracket to the woofer
bracket
Place the Terminal
Bracket edge into the hole
on the TV Stand foot
2 D5 Board
4 B3 Board
3 Two clips
4 V2 Board
(not used for this model)
6 P Board
(not used for
this model)
5 One clip
3 Two clips
1 One clip
Chapters
Table of Contents
