Speed Adjusting Dial - Makita dur361u Instruction Manual
Hide thumbs
Also See for dur361u:
- Instruction manual (172 pages) ,
- Technical information (16 pages) ,
- Instruction manual (129 pages)
Table of Contents
Available languages
Available languages
Push the power button on the housing so that the tool is
powered on and power indicator lights.
1
2
013807
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided.
To start the tool, press the lock-off button and then pull
the switch trigger. Release the switch trigger to stop.
NOTE:
After the power button is pushed and the tool is
•
left one minute without any operations, the tool is
automatically powered off.
Reversing Switch for Debris Removal
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
removing weeds or debris entangled in the tool
that could not be removed when operated in
the reverse mode. Failure to switch off and
remove the battery cartridge may result in serious
personal injury from accidental start-up.
1
2
013835
This tool has a reversing switch which is only provided
to change the direction of rotation so that it can be used
to remove weeds and debris entangled in the tool. To
operate the tool normally the "A" side of the switch
should be depressed.
To remove weeds and debris that are jammed in the
rotating head the tool can be reversed by depressing
the "B" side of the switch. In the reverse position the
tool will only operate for a short period of time and
automatically shut off.
NOTICE:
Always check the direction of rotation before
•
operation.
1. Lock-off button
2. Switch trigger
1. Reversing
switch
2. A position
depressed for
normal operation
3. B position
3
depressed for
weed and debris
removal
10
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage it.
Speed adjusting dial
014748
The tool speed can be adjusted by turning the adjusting
dial. Turn the speed adjusting dial clockwise for higher
speed, and counterclockwise for lower speed.
Nylon cutting head (optional accessory)
NOTICE:
Do not attempt to bump feed the head while the
•
tool is operating at a high RPM. Bump feeding at a
high RPM may cause damage to the nylon cutting
head.
The bump feed will not operate properly if the
•
head is not rotating.
014839
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating at a
low RPM.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord.
ASSEMBLY
WARNING:
Always be sure that the tool is switched off
•
and battery cartridge is removed before
carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may
result in serious personal injury from accidental
start-up.
1. Speed adjusting
dial
1
1. Most effective
1
cutting area
Chapters
Table of Contents
