1 Specifications Model No. MC-CG381 Power source 230 V~50 Hz Input power (MAX) 1500 W Input power (Nominal) 1200 W Power control Extension wand Metal x 2 Dimensions (WxLxH)mm 240x350x250 Net weight 3.8kg Multipurpose accessory...
3 Troubleshooting Guide CONDITION CHECK POINT METHOD OF INSPECTION TRANSACTION Motor fails to rotate Power supply cord Check power supply cord continu- If there is no continuity, replace the (no noise is heard at all) ity. cord reel patition unit. Motor fails to rotate Fuse of P.C.B.
4 Disassembly and Assembly Instructions Important notice: Before replacing any components, make sure to turn OFF the vacuum cleaner. Remove the power plug from the outlet. * Caution: 1. Do not attempt to modify the machine, parts, etc. when marking repairs. 2.
3. Lift the upper body U to separate it from the lower body. 2. Lift the cord reel partition ass'y from the lower body. 3. Remove the two lead wires connected to the cord reel 4.3. Removal of the cord reel U partition ass'y.
4.4. Removal of the P.C.B. ass'y 4. Remove the cord reel partition ass'y. and motor 1. Remove the motor case U with the motor and the P.C.B. ass'y fitted from the lower body. 5. Push the brake lever and loosen the spring winding the cord (loosen the pre-winding).
Page 9
3. Remove the motor support front from the motor and then 5. Remove the noise supporessor, motor support rubber cut the Wire band fixing the thermal protection device to (rear), and motor support rubber (front). remove it. 4. Remove the lead wire, from the P.C.B., connected to the motor ass'y terminal.