Install The Print Head - Canon PRO-4000S Setup Manual

1

When the instruction to open the top

cover appears on the screen, open the

top cover.

Instructions are now shown on the screen

regarding print head installation.

4

Remove the print head from the box

and bag, and peel off the fixing tape.

Grasp the blue handle and remove the

print head.

6

Insert the print head into the carriage with the ink holes (A) on the upper side and facing

towards you as shown in the figure. Carefully push the print head firmly into the carriage,

ensuring that the part covered by the protective caps does not touch the carriage.

A

8

Push the print head lock lever

way in until it makes a click sound.

2

Tilt the print head lock lever

you while pressing the button in the

middle. Remove the protective sheet if

there is one attached.

5

Remove the orange protective caps (2

pieces).

9

Close the top cover.

all the

towards

8

3

Grasp the grip in the center of the print

head locking cover

and open it. Do not

touch the contacts (A) on the carriage.

• Do not touch any part other than the

handle or put down the unit.

Important

• The print head contains ink, so be

careful not to spill it once the protective

caps are removed.

• Do not reattach the protective caps

after removing them. Dispose of them

according to local regulations.

7

Pull the print head locking cover

toward the front to lock the print head in

place.

• If the roll unit is installed, the roll unit

calibration starts automatically after the

Note

print head is attached.

If the roll holder is mounted on the roll

unit at this time, calibration cannot be

executed. Do not mount the roll holder

on the roll unit until the setup has

finished.

A

down