D.12 Parameter Transfer Routes - Siemens S7-300 Operating Instructions Manual
Fm 352 electronic cam controller
Hide thumbs
Also See for S7-300:
- Manual (676 pages) ,
- Reference manual (574 pages) ,
- Installation and operating manual (356 pages)
Table of Contents
Programming without SFB 52 and SFB 53
D.12 Parameter transfer routes
Some use cases for the transfer of parameters
Use case
You edit the parameters on the parameter assignment interface.
The parameters should then be assigned automatically to the
module during startup.
You modify parameters for commissioning in test mode in the
parameter assignment interface:
The parameters modified during commissioning should be
downloaded automatically during startup.
You create the parameters using the parameter assignment
interface. When it starts up, the module should be assigned
parameters only by the user program via data blocks.
You want to create convenient data sets for recipes.
You create the parameters using the parameter assignment
interface. These should be available to the user program for
temporary modifications.
You modify existing parameters (exclusively) using the user
program.
You want to view the data modified by the user program on the
parameter assignment interface.
Parameters modified by the user program should also be loaded
automatically during startup.
218
Steps
Perform steps 1, 2, and 3.
Perform steps 4 and 5
Perform steps 1, 2, and 3.
Perform steps 10 and 6.
Perform step 10.
Perform steps 1, 2, and 3 for
automatic parameter
assignment. Perform steps 10,
7 to enable access by the user
program.
Perform steps 7, 9, 8, and 6.
Perform step 11.
Perform steps 6, 11, 1, 2, and
3.
FM 352 electronic cam controller
Operating Instructions, 05/2011, A5E01071724-03
Hide quick links:
Table of Contents
