Battery charger (EY0020/RE503)···(H)
NOTE: When you charge the battery pack for
the first time, or after prolonged
storage, charge it for about 24 hours to
bring the batteries up to full capacity.
1. Press the battery pack release button and
pull the pack away from the tool.
(Refer figure 8)
2. Plug the charger into the power source.
3. Insert the battery pack firmly into the
charger.
(Refer figure 9)
4. During charging, the charging lamp will be
light up.
When the charge is completed, an internal
electronic switch will automatically be
triggered to prevent overcharging.
• If the charging lamp does not light, check
to determine whether the contacts are
clean and the battery pack is inserted
completely.
5. When charging is completed, the charging
lamp will go out.
6. Avoid charging at temperatures below 0°C
above 40°C.
7. After charging has been completed,
remove the battery pack from the charger
and reinsert it into the tool.
(Refer figure 10)
8. If the charging lamp does not turn on
immediately afater the chager has been
plugged in, or if after 2 hours of charging
the lamp does not go off, consult an
authorized dealer for checking.
NOTE: The battery pack EY9021 can be
charged by 15 min. charger EY0202
using adapter EY0890.
CAUTION: • Do not use power source from
an engine generator.
• Do not cover vent holes on the
charger.
• Unplug the charger when not in
use.
Page 6