Table of Contents
Chapter 8
Installation with Cisco Cabinets including 7000 Series Routers
Installing Router Assembly in a Cisco Cabinet
To install the router enclosure assembly in BPX 8650 cabinet (see Figure 8-7), use the following
procedure:
Slide the router enclosure assembly into the cabinet on top of the BPX shelf.
Step 1
Attach the two support brackets from the hardware kit, one to each vertical rail at the back of the cabinet
Step 2
as shown using two screws to secure each. The support brackets have a horizontal flange that supports
the router enclosure assembly.
Secure the front of the router assembly to the cabinet rails with two screws on each side.
Step 3
Secure the router enclosure assembly to the cabinet with mounting screws.
Step 4
Connect the power cord to router connector receptacle at the front of the cabinet, and close the router
Step 5
enclosure assembly door.
Use the tie wraps provided in the hardware kit to secure power cord to a Cable Management Bracket.
Step 6
If this is a DC-powered shelf, proceed to Chapter 10, "Installing the DC Shelf."
Step 7
If this is an AC-powered shelf, proceed to Chapter 11, "Installing the AC Shelf."
Step 8
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Installing a 7200 or 7500 Router in a BPX 8650 Cabinet or Rack
Cisco BPX 8600 Series Installation and Configuration
8-9
Table of Contents
Troubleshooting
