Table of Contents
Available languages
Available languages
Dismantling:
•
Loosen the coupling by turning the knob (at least 3
times).
•
Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
C
Assembling the cutting
equipment
WARNING!
!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
12 – English
ASSEMBLY
Fitting the trimmer guard and
trimmer head
•
Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
•
Fit the drive disc (B) on the output shaft.
•
Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.
•
To dismantle, follow the instructions in the reverse
order.
A
H
H
B
C
A
- Quick Links:
- Two-Piece Shaft
Hide quick links:
Chapters
Table of Contents
