Table of Contents
Pl%£
i
Apply g r e a s e ^ N
?
/ ' ^ \ - ^ ^ ^
\
HT^
Apply grease
N.
® « ^ ,
Apply g r e a s e — y y ^ ^ M r
Recommended grease:
Lithium base wheel bearing grease
(EX. SHELL LETHINAX A)
Tightening torque.
Drive shaft housing screw
Rear arm comp.
5.0 m -kg (36 ft-lb)
holding screw:
2.5 m-•kg(18ft-lb)
6. Housing cover installation
When installing the housing cover,
make sure that the 0-ring is correctly
fitted in the groove on the cover.
1. O-ring
5-4. FRONT FORKS
A. Disassembly
1. Remove the rear brake cable and starter
wire from the handlebars.
2. Remove the headlight unit and front
panel 1, and disconnect lead wires.
3. Remove front panel 2, plate, front carri-
er, and ball race cover.
4. Loosen the fitting nuts (two pieces).
Loosen the handlebar fitting bolt, re-
move the handlebar complete by tap-
ping the bolt with a soft-faced hammer,
and the handlebar complete can now be
removed from the front fork assembly.
Next, remove the fitting nuts (two
pieces), horn and carrier bracket.
5-8
- Quick Links:
- Engine and Transmission Oil
- Carburetor
Hide quick links:
Chapters
Table of Contents
