SAFETY INFORMATION - GM-X374/XR/UC CAUTION This service manual is intended for qualified service technicians; it is not meant for the casual do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained to properly and safely repair complex products such as those covered by this manual.
NOTE: - Parts marked by “*” are generally unavailable because they are not in our Master Spare Parts List. - Screws adjacent to ∇ mark on the product are used for disassembly. - For the applying amount of lubricants or glue, follow the instructions in this manual. ( In the case of no amount instructions, apply as you think it appropriate.) - PACKING SECTION PARTS LIST Mark No.
3. SCHEMATIC DIAGRAM 3.1 OVERALL CONNECTION DIAGRAM(GUIDE PAGE) AMP UNIT Large size SCH diagram GAIN = 1 Guide page Detailed page GAIN = -12dB INPUT SELECT GAIN = 1 UC ONLY EW, ES ONLY BEADS CORE (EW, ES ONLY) 75µH 75µH EW, ES ONLY BEADS CORE...
AMPLIFIER GAIN = 5.2 - 35.4dB HPF/LPF SELECT 10kΩ(A) 10kΩ(A) HPF/LPF SELECT 10kΩ(A) 10kΩ(A) R608 R609 1R3K 1R3K EW, ES 6R2K 6R2K EW, ES ONLY EW, ES ONLY 50µH FU602 HEK0030 > UC ONLY NOTE : Symbol indicates a resistor. Decimal points for resistor No differentiation is made between chip resistors and and capacitor fixed values...
4. PCB CONNECTION DIAGRAM 4.1 AMP UNIT NOTE FOR PCB DIAGRAMS AMP UNIT 1.The parts mounted on this PCB include all necessary parts for several destination. For further information for respective destinations, be sure to check with the schematic dia- gram.
5. ELECTRICAL PARTS LIST NOTES: - Parts whose parts numbers are omitted are subject to being not supplied. - The part numbers shown below indicate chip components. Chip Resistor RS1/_S___J,RS1/__S___J Chip Capacitor (except for CQS..) CKS.., CCS.., CSZS..=====Circuit Symbol and No.===Part Name Part No.
7. GENERAL INFORMATION 7.1 DIAGNOSIS 7.1.1 DISASSEMBLY Removing the Case (not shown) 1. Remove the eight screws and then remove the Case. Panel Removing the Amp Unit (Fig.1) Remove the eight screws. Remove the two screws and then remove the two Panels. Remove the eight screws and then remove the two Heat Sinks.
7.1.2 CONNECTOR FUNCTION DESCRIPTION - GM-X374/XR/UC 6.5V 0.2V 6.5V 0.2V BRIDGEABLE 4-CH POWER AMPLIFIER FUSE 30A GM-X374/XR/UC...
Page 23
7.2 IC *TDA7294V MUTE THERMAL STBY SHUTDOWN PROTECTION IC's marked by * are MOS type. Be careful in handling them because they are very liable to be damaged by electrostatic induction. GM-X374/XR/UC...
Connection Diagram Ground wire (black) [RD-223] (sold separately) Connect to metal body or chassis. Fuse (30 A) Special red battery wire [RD-223] (sold separately) After making all other connections at the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery.