Carrying power tools with your fi nger on the switch GENERAL POWER TOOL SAFETY or energising power tools that have the switch on WARNINGS invites accidents. d) Remove any adjusting key or wrench before WARNING turning the power tool on. Read all safety warnings and all instructions.
l) Never lay the power tool down until the accessory SAFETY WARNINGS COMMON FOR has come to a complete stop. GRINDING OR ABRASIVE CUTTING- The spinning accessory may grab the surface and pull the power tool out of your control. OFF OPERATIONS m) Do not run the power tool while carrying it at your side.
c) The guard must be securely attached to the power – Inspect the grinding wheel before use, do not use tool and positioned for maximum safety, so the least chipped, cracked or otherwise defective products; amount of wheel is exposed towards the operator. –...
Thickness 4 mm 6 mm Peripheral speed 72 m/s 80 m/s Weight (only main body) 1.7 kg 1.8 kg NOTE Due to HITACHI’s continuing program of research and development, the specifi cations herein are subject to change without prior notice.
3. Inspecting the carbon brushes For your continued safety and electrical shock protection, carbon brush inspection and replacement on this tool should ONLY be performed by a HITACHI AUTHORIZED SERVICE CENTER. 4. Replacing supply cord If the replacement of the supply cord is necessary, it has to be done by Hitachi Authorized Service Center to avoid a safety hazard.