Name Of Each Part; Indoor Unit; Remote Controller; Preparation Before Operation - Mitsubishi Electric MSZ-FD25VA Operating Instructions Manual
Hide thumbs
Also See for MSZ-FD25VA:
- Operating instructions manual (124 pages) ,
- Service manual (40 pages) ,
- Manual (586 pages)
Table of Contents
Available languages
Available languages
● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Display section
Operation
indicator
lamp
Front panel
Air fi lter
Air inlet
Plasma
deodorizing
fi lter
Plasma elec-
trode unit
Page 7
Plasma
anti-allergy
i-see sensor
enzyme fi lter
Air outlet
Fan guard
Fan
Horizontal vane
Vertical vane
Outdoor unit
Appearance of the outdoor unit may differ from some models.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
Be sure to set the installation position before installing the batteries.
1.
Remove the front lid
3.
Install the front lid
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries. The remote controller could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
En-3
Remote control
receiving section
Page 4
Heat
Emergency
exchanger
operation
switch
Page 5
Air inlet (back and side)
Piping
Drainage hose
Air outlet
Drain outlet
Page 4
2.
Insert AAA
alkaline batteries
Remote controller
Operation display
section
ON/OFF
(operate/stop)
button
Operation select
button
Page 5
FAN speed
control button
Page 6
ECONO COOL
button
Page 7
PLASMA button
Page 7
VANE
control button
Page 6
CLEAN button
Page 7
Lid
Slide down
to open
Use the remote controller provided with the unit only.
Do not use other remote controllers.
Setting current time
1.
Press RESET
2.
Press CLOCK
4.
Press CLOCK again
• Press RESET and CLOCK gently using a thin
stick.
If the RESET button is not pressed, the remote
controller may not operate correctly.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 5
Off-timer button
Page 7
On-timer button
Page 7
WIDE VANE
button
Page 6
TIME set buttons
Pages 3, 7
Increase time
Decrease time
AREA button
Page 4
CLOCK button
Page 3
RESET button
Page 3
i-see button
Page 4
Remote controller
holder
• Install the remote control-
ler holder to a place where
the signal can be received
by the indoor unit.
3.
Press the TIME buttons to set the
time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer)
- Quick Links:
- Remote Controller
- Indoor Unit
- Heat Mode
Hide quick links:
Table of Contents
