Honeywell Electrode Steam Homeowner's Manual
  1. Manuals
  2. Brands
  3. Honeywell Manuals
  4. Humidifier
  5. Electrode Steam
  6. Homeowner's manual

Honeywell Electrode Steam Homeowner's Manual

Hide thumbs
Table of Contents

Quick Links

Electrode Steam Homeowner's Manual
HOMEOWNER'S OPERATING MANUAL
33-00165-01
Table of Contents
loading

Related Manuals for Honeywell Electrode Steam

Summary of Contents for Honeywell Electrode Steam

  • Page 1 Electrode Steam Homeowner’s Manual HOMEOWNER’S OPERATING MANUAL 33-00165-01...

  • Page 3: Table Of Contents

    Electrode Steam have? . . . . . . . . . . . . . . . . . . 3...

  • Page 4: Safety Definitions And Precautions

    The Electrode Steam uses 120V or 240V, which can cause death or serious injury. Take precautions when service is being preformed on the Electrode Steam or when removing the water tank or cover. If in doubt, turn off the breaker which is operating the Electrode Steam and disconnect HVAC equipment power before servicing.

  • Page 5: Welcome

    Electrode Steam has just been installed, it should either be running and humidifying your home, or waiting for a humidity call from the humidity control provided. Once the Electrode Steam is up and running, all you have to do is use the humidity control to change the humidity to your desired comfort.

  • Page 6: How Does The Electrode Steam Work

    The condensate must be collected and removed from the system so that it does not build up and leak into the duct. Condensate can be returned to the Electrode Steam fill cup to reduce water waste or can be fed to drain.

  • Page 7: Which Electrode Steam Model Do I Have

    The Electrode Steam is available in two sizes, each with a different humidifying capacity: The Electrode Steam produces 11 gallons per day (GPD) when run on 120 V and 22 GPD when run on 240 V. It is generally suitable for homes 8,000 to 32,000 cubic feet in size.

  • Page 8: Which Humidity Control Do I Have

    Which humidity control do I have? The Electrode Steam comes supplied with a HumidiPRO Digital Control (see below), or you can use your home thermostat (Prestige IAQ, VisionPro, or Lyric). You will use the humidity control to set the desired humidity level for your home, and to turn the Electrode Steam on and off.

  • Page 9: What Electrode Steam Parts Do I Need To Know

    What Electrode Steam parts do I need to know? You should be familiar with the following components: Steam Hose: Conduit to transfer the steam from the humidifier to the distributor. On/Off/Drain Switch: Turns power on/off to humidifier controller and drains the cylinder.

  • Page 10: What Should I Expect From My Electrode Steam

    • Unit Not Humidifying. If the Electrode Steam is not running but the humidity is below the desired setting, the humidity control may have a frost protection setting. See “What is a frost setting?” on page 10. The Cylinder may also be at the end of its life, in which case you will be notified by the LED sequence.

  • Page 11: How Do I Operate The Electrode Steam

    How do I operate the Electrode Steam? Once the Electrode Steam is installed and running, operation is automatic. Use the humidity control provided to make any changes to the setpoint, or to turn the Electrode Steam on or off. Your Professional Installer configured the Electrode Steam so that it only creates steam when conditions in your HVAC system are right.

  • Page 12: What Should My Humidity Setpoint Be

    • What should my humidity setpoint be? The outdoor air temperature affects how much humidity can be retained by the air in your home. Use this table as a starting point. Then adjust the humidity control to your own comfort or until condensation appears on the windows. Outdoor Recommended Relative Temperature...

  • Page 13: What Do The Lights Tell Me

    What do the lights tell me? The HM700 user interface includes 2 LEDs that provide information about the humidifier status. Yellow and Green LED Flashing. Indicates there is no request for humidity. Yellow LED Flashing. Fault detected, humidifier has stopped operating. Green LED Flashing.

  • Page 14: What Should I Do At The End Of The Season

    This prevents water from stagnating inside the tank. The Electrode Steam will refill the tank with water and reset itself when your control calls for humidity again.

  • Page 15: 5-Year Limited Warranty

    55422, or whether a replacement product can be sent to you. This warranty does not cover removal or reinstallation costs. This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by damage which occurred while the product was in the possession of a consumer.
  • Page 16 Automation and Control Solutions Honeywell International Inc. 1985 Douglas Drive North Golden Valley, MN 55422 ® U.S. Registered Trademark. © 2015 Honeywell International Inc. 33-00165—01 M .S . 11-15 http://yourhome.honeywell.com Printed in U.S.A.

Table of Contents