Samsung Refrigerator User Manual page 11
Hide thumbs
Also See for Refrigerator:
- User manual (180 pages) ,
- Owner's manual (40 pages) ,
- Owner's manual and installation (32 pages)
Table of Contents
• 6.35mm compression nut
• plastic tubing
Refrigerator
Plastic tubing
(Supplied)
Ferrule
(Not supplied)
copper tubing
(Not supplied)
Household water line
1. Slip the compression nut through the supplied
plastic tubing
.
2. Tighten the compression nut
compression fitting.
- If you are using copper tubing, slip the compression
(not included) and ferrule (not included) on
nut
copper tubing (not included) as shown.
- If you are using plastic tubing
molded end(Bulb) of the plastic tubing
compression fitting.
Do not use without the molded end(Bulb) of the
plastic tubing
.
3. Tighten the compression nut
compression fitting. Do not over-tighten the
compression nut
.
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable water
source. If you have to repair or disassemble
the water line, cut off 6.35mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Installing the water filter.
1. Remove the water filter cover
2. Remove the fixed cap by turning it counter
clockwise. Keep the cap in a safe place for later
use if you don't use the filter.
3. Remove the water filter from the box and put
a replacement indicator sticker on the filter as
shown. Place the sticker on the filter that dates six
months in the future. For example, if you install the
water filter in March, put the "SEP" sticker on the
filter to remind you to replace it in September. That
way you'll know when it is time to replace the filter.
Normally, a filter life is about 6 months.
• copper tubing
• ferrule
Compression nut
(6.35mm) (Supplied)
Compression fitting
(Supplied)
Bulb
Compression nut
(6.35mm) (Not
supplied)
plastic tubing
or
(Not supplied)
4. Remove the filter cap and insert the filter into the
5. Slowly turn the water filter 90º clockwise to align
onto the 6.35mm
, insert the
into the
onto the
Removing any residual matter inside
the water supply line after installing
the water filter.
.
1
1. Turn ON the main water supply & turn OFF the
2. Run water through the dispenser until the water
3. Additional flushing may be required in some
4. Open the Refrigerator door and make sure there
that there is still air in the line.
2
filter housing.
with the printing mark on the cover, locking the
filter in position.
Make sure to align the water filter label mark
with center of cover filter printing as illustrated.
Remember, do not overtighten.
Cover filter
4
Separation
of red cap.
You should remove the right side upper glass
shelf before installing the water filter.
valve to the water supply line.
runs clear (approx. 6-7minutes). This will clean the
water supply system and remove air from the lines.
households.
are no water leaks coming from the water filter.
Be sure to flush the dispenser thoroughly or
water may leak from it. This is due to the fact
1
3
Sticker
(month indicator)
5
Turn until
the label is
aligned.
_11
Setting up
Table of Contents
Troubleshooting
