Panasonic MKG1301913, MKG1302913 - Temperature/Humidity Sensor Manual

• Please read this manual carefully to ensure safe use.
  Be sure to read the "Safety Warnings" section prior to use.

Accessories

Safety Warnings

Mandatory
Be careful to stand securely when attaching or removing the device, to allow safe working.
Failure to do so may lead to injury through falling or dropping.
Insertion and exchange of the battery and handling of pan head tapping screws should be done out of the reach of infants and children.
Failure to do so may lead to accidental ingestion or injury.

Mandatory
Fix securely.
Insecure fixing may lead to the product dropping, causing injury or damage to flooring or other objects.
Attach to a structurally sound point, such as wall framing*. Strengthen weak or flexible walls before attaching.
Failure to follow this may lead to the product dropping, causing injury or damage to other objects.
*Framing: wooden structure on which the wall is mounted.

Prior to Use

Note
There may be a delay between a change in temperature or humidity and detection by the internal sensor, due to the time required for the internal environment to balance (i.e. the device cannot respond to very rapid changes in temperature and humidity).

Cautions for Installation

• This product is for use with Panasonic's Home IoT Gateway.
• Up to 8 devices can be registered with the Home IoT Gateway.
• The MKG1301913 (Indoors) is for indoor use only. Do not position where rain could fall or somewhere with high humidity such as a bathroom.
• Site the MKG1302913 (Outdoors) away from direct rainfall and away from direct sunlight. While the device is rain resistant, it should not be deliberately wet, such as with a hose.
• Think carefully about the installation site to ensure accurate measurements. Do not position where it could be subject to high temperatures, steam, or air flow due to nearby doors and windows. Do not position where it could be affected by tobacco smoke, oil from kitchens, or dusty areas, as this can contaminate the sensors.
• Be sure to follow the rules below, as these may cause breakdown, damage or failure of operation.
  • Do not use in a place with sea breezes, such as on the beach.
• The radio transmission distance for the Home IoT Gateway and Temperature/Humidity Sensor is approximately 100 m, assuming a level, unobstructed line of sight.
• The radio transmission range will be reduced in the following usage environments due to radio noise. In such a case, the device may not function.
  • If a radio wave barrier such as metal or reinforced concrete is present between the devices.
• Please test operation at the site of use in advance. The radio transmission should be checked periodically, as the usage environment (radio environment) may change after installation.
• We recommend that there should be no more than one barrier between the Home IoT Gateway and Temperature/ Humidity Sensor such as steel-reinforced concrete or glass wool insulation. The Temperature/Humidity Outdoor Sensor should also be sited at the same height at the Home IoT Gateway (radio signal may be insufficient due to the location of furniture, even within the recommended range).

Names and Functions of Components

1. Sensor
   Note
   Do not cover the sensor.
   Do not insert anything into the grill.
2. Low Battery Lamp (Red)
   Note
   The battery should be replaced once depleted. Please contact Panasonic.

Inserting the Battery

Installation

1. Attach the base to a flat wall.
   • Make sure that the arrow "" is pointing up.

Fixing Height

Specifications

* Lifespan may be shorter due to usage environment and signal status (e.g. if radio signal is too weak or Home IoT Gateway is not plugged in).

CE Certification

Hereby, Panasonic declares that the radio equipment type (MKG1301913/MKG1302913) is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.ptc.panasonic.eu/