Please read these instructions carefully before using this product, and save this manual for future use.
Please check and identify the supplied accessories.
Only for U.S.A.:
To order accessories, refer to "Limited Warranty".
Only for Canada:
To order accessories, contact the dealer from whom you have made your purchase.
1 x USB charging cord
Use only the supplied USB charging cord when connecting to a computer.
*1 : Standby/ON
*2 Hereafter referred to as "LED"
The rechargeable battery (installed in the unit) is not charged initially. Charge the battery before using the unit.
Connect this unit to a computer () using the USB charging cord (supplied) ().
Press and hold () of this unit for approx. 3 seconds until the LED (blue) () blinks.
To turn the power off
Press and hold for approximately 3 seconds. A beep will sound and the power will be turned off.
Connect the Bluetooth® device and the unit.
Select and play the music on the Bluetooth®device.
(Operation example)
Play / Pause: Press .
Increase the volume: Press .
Decrease the volume: Press .
Forward to the start of next track: Press and hold for approximately 2 seconds.
Return to the start of current track: Press and hold for approximately 2 seconds.
Press and hold of this unit for approx. 3 seconds.
The following instructions are not intended for repairing purposes but for the disposal of this unit. This unit is not restorable once disassembled.
|
Regarding the handling of used batteries
Clean this unit with a dry and soft cloth.
Power supply | DC 5 V, 330 mA (Internal battery: 3.7 V (Li-polymer 430 mAh)) |
Operating time*1 | Approx. 24 hours |
Charging time*2 (25 oC (77 oF)) | Approx. 3.5 hours |
Charging temperature range | 10 oC to 35 oC (50 oF to 95 oF) |
Operating temperature range | 0 oC to 40 oC (32 oF to 104 oF) |
Operating humidity range | 35%RH to 80%RH (no condensation) |
Mass (Weight) | Approx. 190 g (6.7 oz) |
Frequency band | 2402 MHz to 2480 MHz |
Supported profiles | A2DP, AVRCP, HSP, HFP |
Supported codec | SBC |
*1 It may be shorter depending on the operating conditions.
*2 Time taken to recharge from empty to full.
Before requesting service, make the following checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to "Customer Services Directory" if you reside in the U.S.A., or refer to "CONTACT INFORMATION" if you reside in Canada.
The unit does not respond.
Cannot charge the unit.
LED does not light during charging. / Charging takes longer.
The power does not turn on.
The device cannot be connected.
No sound.
Low volume.
Sound from the device is cut off. / Sound quality is bad.
You cannot hear the other person.
Cannot make a phone call.
The serial number of this product can be found on the left side of the headphones. Remove the left earpad to see it. Please note them and keep for future reference. MODEL NUMBER: RP-HTX80B SERIAL NUMBER: |
Read these operating instructions carefully before using the unit. Follow the safety instructions on the unit and the applicable safety instructions listed below. Keep these operating instructions handy for future reference.
For the U.S.A. and Canada only A lithium ion battery that is recyclable powers the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle this battery. |
THE FOLLOWING APPLIES ONLY IN THE U.S.A. AND CANADA. This device complies with Part 15 of FCC Rules and Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: FCC ID: ACJ-RP-HTX80B This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption ratio (SAR). |
THE FOLLOWING APPLIES ONLY IN THE U.S.A. FCC Note: These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Any unauthorized changes or modifications to this equipment would void the user's authority to operate this device. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: Responsible Party: Panasonic Corporation of North America Support Contact: http://shop.panasonic.com/support |
THE FOLLOWING APPLIES ONLY IN CANADA. CAN ICES-3(B)/NMB-3(B) |
To reduce the risk of fire, electric shock or product damage,
|
This unit may receive radio interference caused by mobile telephones during use. If such interference occurs, please increase separation between this unit and the mobile telephone.
This unit is intended for use in moderate and tropical climates.
Register online at http://shop.panasonic.com/support (U.S. customers only)
If you have any questions, visit:
In the U.S.A.: http://shop.panasonic.com/support
In Canada: www.panasonic.ca/english/support
Panasonic Corporation of North America
Two Riverfront Plaza, Newark, NJ 07102-5490
http://shop.panasonic.com
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3
www.panasonic.com
© Panasonic Corporation 2017
Printed in China
TQBM0147
F0917HA0
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the RP-HTX80B that isn't answered in the manual? Leave your question here.