Bs 1 - Bosch rexroth BS 1 Series Assembly Instructions Manual

30/40

Maintenance and repair

1.

Loosen the four

hexagonal screws

M5x16 (SW 8) with lock

washers at the gear

flange (D).

2.

Remove the defective

gear (F) from the

motor (J).

3.

Remove the yellow

protective cap (X) from

the new motor.

4.

Lubricate the motor

shaft (Y) (e.g. with

"gleitmo 585K").

Then secure the new

motor at the gear flange.

Bosch Rexroth AG, MIT: BS 1/..., 3 842 563 815/2021-11

10.4.3 BS 1/..., external motor mounting (MA) = R/L, motor replacement

Fig. 18: External motor mounting, motor replacement

Please note:

• The end faces of the motor and gear must be undamaged.

• The gear hub comes lubricated with anti-seize lubricant.

• Do not tilt the motor, and make sure it has the necessary clearance area for

installation.

• Install the motor in the proper position (terminal box) and connect it to the gear.

If the motor is not installed in proper position: do NOT rotate the motor.

Disconnect the motor from the gear and reconnect it.

F

D

4

1

Y

"gleitmo 585K"

SW 8

(4x)

X

2

3

J