Related Manuals for Hitachi CN7721-Y
Summary of Contents for Hitachi CN7721-Y
-
Page 1: Instruction Manual
PCI-Express Dual Port Gigabit LAN Card Instruction Manual (Model: CN7721-Y) INKS Document Organization Getting Help Contents MK-90CRH019-01... - Page 2 Hitachi, Ltd. (hereinafter referred to as "Hitachi"). Hitachi reserves the right to make changes to this document at any time without notice and assumes no responsibility for its use. This document contains the most current information available at the time of publication.
-
Page 3: Table Of Contents
Contents Regulatory compliance notices ................vi Federal communications commission (FCC) compliance (U.S.A) ......vi Canadian compliance statement (Canada) ............vi European union notice (EU)................vi Acoustics noise (Germany) ................vi Product recycling and disposal (EU and Norway) (Waste Electrical and Electronic Equipment Directive 2002/96/EC [WEEE]) ............. - Page 4 Names and function of components ............3-1 Names and functions ..................3-2 Installing the Card.................4-1 System configuration and installation method ............. 4-2 How to connect the Card .................. 4-2 Connecting a LAN cable................4-2 Installing a driver ..................5-1 Windows 2008 R2 environment ................. 5-2 Procedure for installing the driver for Windows 2008 R2 .......
- Page 5 Preface This manual describes how to install and handle the Hitachi PCI-Express Dual Port Gigabit LAN Card (hereinafter referred to as the LAN Card). Regulatory compliance notices Intended audience Document revision level Document organization Document conventions Safety information Getting help...
-
Page 6: Regulatory Compliance Notices
Regulatory compliance notices Federal communications commission (FCC) compliance (U.S.A) Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. -
Page 7: Product Recycling And Disposal (Eu And Norway) (Waste Electrical And Electronic Equipment Directive 2002/96/Ec [Weee])
Product recycling and disposal (EU and Norway) (Waste Electrical and Electronic Equipment Directive 2002/96/EC [WEEE]) The following mark on Products indicates that these Products are to be collected separately and to be recycled or discarded according to applicable local and national regulations. For further information regarding return, collection, recycle or disposal, please contact your sales company where you purchased the Products. -
Page 8: 電波障害自主規制 (Japan)
Class A emission statement (Korea) 이 기기는 업무용(A급) 전자파적합기기로서 판 매자 또는 사용자는 이 점을 주의하시기 바라 며, 가정외의 지역에서 사용하는 것을 목적으로 합니다. / 상호명： 히다찌(주) Applicant LG Hitachi Ltd r / 제조자： Manufacture HITACHI, LTD / 제조국： / 일본 Origin Japan BSMI compliance (Taiwan) 法規遵循公告... -
Page 9: International Compliance
International compliance Standard / Marking Classification Country UL 60950-1 Safety U.S.A FCC 47 CFR Part 15 Class A Limit This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause... -
Page 10: Intended Audience
Intended audience This document is intended for the personnel who are involved in planning, managing, and performing the tasks to prepare your site for Compute Rack installation and to install the same. This document assumes the following: • The reader has a background in hardware installation of computer systems. •... -
Page 11: Document Conventions
The service information messages, including reference codes and severity levels, displayed and/or logged at the Compute Rack The Hitachi Data Systems support staff are available 24 hours a day, seven days a week. For technical support, visit the portal site at https://portal.hds.com. For contact information, visit www.hds.com. -
Page 12: Comments
Please send us your comments on this document, if any, by e-mail to: [email protected] Make sure that the e-mail includes the document title and number, revision, and section(s) and paragraph(s) whenever possible. Thank you! (All comments become the property of Hitachi.) Preface PCI-Express Dual Port Gigabit LAN Card Instruction Manual... - Page 13 Safety guidelines This section contains warnings and important safety guidelines for using a Hitachi Compute Rack System. Read and understand the information in this section before removing, replacing and installing system components. This section includes the following key topics: Safety information...
-
Page 14: Safety Information
Safety information This document uses the following symbols to emphasize certain information. Symbol Label Description This indicates the presence of a potential risk that might cause death or WARNING severe injury. This indicates the presence of a potential risk that might cause relatively CAUTION mild or moderate injury. -
Page 15: Common Precautions Concerning Safety
Common precautions concerning safety Please carefully read through these safety instructions to follow: • When operating the equipment, follow the instructions and procedures provided in the manual. • Be sure to follow notes, cautionary statements and advice indicated on the equipment or in the manual. -
Page 16: Precautions Marks In This Manual
Mounting this product Mount and use this product in a system unit that supports installation and operation of this product. If mounted in any other system, this product causes a failure due to difference in connection specifications. For information about which system units support this product, see the manual of the individual system unit. -
Page 17: Before Use
Before use This chapter provides the information you have to know before connecting and setting the LAN Card. For your confirmation Before use PCI-Express Dual Port Gigabit LAN Card Instruction Manual... -
Page 18: For Your Confirmation
For your confirmation Confirm the following matters before use. If you should have a problem with the product, contact the sales representative. • Is it the model or type you ordered? • Are there any parts damaged during shipping? • Are all the accessories of the Accessory List included in the package? If a separate sheet of additional information is included, be sure to read it. -
Page 19: Product Overview
Product overview This chapter describes the product overview. Features Product overview PCI-Express Dual Port Gigabit LAN Card Instruction Manual... -
Page 20: Features
Features This card is used by being attached to the PCI-Express expansion slot (hereinafter referred to as PCI slot) of the system unit. This product has the following features. • It supports 1000BASE-T (IEEE802.3ab) and equipped with 4 ports for network interface connectors. -
Page 21: Names And Function Of Components
Names and function of components This chapter describes the names and functions of components of this Card. Read this chapter before you install the Card on the system unit. Names and functions Names and function of components PCI-Express Dual Port Gigabit LAN Card Instruction Manual... -
Page 22: Names And Functions
Names and functions (5) MAC address (rear) (1) RJ-45 Port 0 (1) RJ-45 Port 1 (2) LINK/ACT LED (3) 100 M SPEED LED (4) 1000 M SPEED LED Figure 3-1 (1) RJ-45 connector Connects a LAN cable. At 10 Mbps: Category 3, category 4, category 5, and enhanced category 5 At 100 Mbps: Category 5 and enhanced category 5 At 1000 Mbps: Enhanced category 5 (2) LINK/ACT LED... - Page 23 (4) 1000M SPEED LED Color Status Indication 1000 Green Connected to HUB of 1000 Mbps Connected to HUB of 10 or 100 Mbps (5) MAC address 1st to 12th digits obtained from IEEE (one MAC address possessed) Names and function of components PCI-Express Dual Port Gigabit LAN Card Instruction Manual...
-
Page 25: Installing The Card
Installing the Card This chapter describes how to install the Card on the system unit. System configuration and installation method How to connect the Card Installing the Card PCI-Express Dual Port Gigabit LAN Card Instruction Manual... -
Page 26: System Configuration And Installation Method
System configuration and installation method Install the LAN Card into the PCI slot of the system unit. For the procedures to install the system unit, see the manual supplied with the system unit. When this Card is replaced, its specific information (example: MAC address) is changed. - Page 27 1. Push the lock of the twisted pair cable's connector slightly and insert the cable into the connector of the LAN Card until it locks. 2. Push the connector lock at the other end of the twisted pair cable slightly and insert the cable into the connector of the hub until it locks.
-
Page 29: Installing A Driver
Installing a driver This chapter describes how to install the network driver of the LAN Card in the Windows 2008 R2 environment. When the LAN expansion function is used, see "Instructions for Setting the LAN Expansion Function" contained in the " Drivers Kit ****-10-**"... -
Page 30: Windows 2008 R2 Environment
When connecting the LAN cable to the network interface connector, the drivers bundled in the Windows 2008 R2 cannot be used. When CN7721-Y or CN7721-R LAN Card is added, be sure to apply the driver in the "Drivers Kit ****-10-**" CD. (* is an arbitrary number). If the driver is preinstalled as a factory expanded model, it is not necessary to install. - Page 31 The Update Driver Software window opens. Click Browse my computer for driver software. On the Update Driver Software window, insert the "Drivers Kit ****- 10-**" CD. (* is an arbitrary number). into the CD-ROM or DVD-RAM drive and enter the directory shown below. Then click Next. Table 5-1 LAN driver storage location Windows 2008 R2...
- Page 32 If the driver has been already updated to the latest version, the following window will open. In this case, click Close. 6. The Property window opens. Click the Driver tab and then click Uninstall. Click OK 7. For the device whose device driver has not been updated, repeat steps 2 to 6.
- Page 33 9. Check the IP address. The initial value is obtained automatically. If the fixed valuse is to be used, it is necessary to change the IP address setting. After setting, check to connect the LAN cable to its destination such as a hub and then restart the system unit.
-
Page 34: Procedure For Setting A Fixed Communication Speed
Procedure for setting a fixed communication speed 1. Click Hardware of Control Panel and then click Device Manager of Devices and Printers. In the Device Manager window, double-click Broadcom NetXtreme Gigabit Ethernet under Network adapters. 2. In the Property window, click the Advanced tab and then click Link Speed &... -
Page 35: Supplementary Note On Lan Card Function
Supplementary Note on LAN Card Function This chapter describes the notes on the LAN Card functions. TCP Checksum Offload function Setup method in each OS Supplementary Note on LAN Card Function PCI-Express Dual Port Gigabit LAN Card Instruction Manual... -
Page 36: Tcp Checksum Offload Function
TCP Checksum Offload function Even though the LAN Card has a function to calculate the TCP/IP checksum, it is recommended to use the operating system's standard TCP/IP checksum calculation function instead of the LAN Card's function. If the TCP/IP checksum is set to be calculated by the operating system, the operating system checks integrity of the packet data received from the network at the final phase of protocol processing. -
Page 37: Troubleshooting
Troubleshooting This chapter describes how to address malfunctions of the LAN Card. Troubleshooting PCI-Express Dual Port Gigabit LAN Card Instruction Manual... - Page 38 This chapter describes actions to be taken when the LAN Card does not operate properly. If a problem remains after the following actions are taken, contact your sales representative or call the maintenance personnel: Table 7-1 Problem Verification & how to take action The LAN Card is not recognized •...
-
Page 39: Specifications
Specifications This chapter describes main specifications of the Card. Hardware specifications Specifications PCI-Express Dual Port Gigabit LAN Card Instruction Manual... -
Page 40: Hardware Specifications
Hardware specifications Table 8-1 Item Specification Communication Supported IEEE802.3 10BASE-T Ethernet functions standards IEEE802.3u 100BASE-TX Fast Ethernet IEEE802.3ab 1000BASE-T Gigabit Ethernet IEEE802.3x Flow Control Data transfer rate 10 Mbps/100 Mbps and Full/Half Duplex 1000 Mbps Full Duplex No. of ports 10/100/1000 Mbps×2 ports (RJ45) Bus interface Compatible with PCI-Express2.0 (No. - Page 41 Hitachi Data Systems Corporate Headquarters 2845 Lafayette Street Santa Clara, California 95050-2639 U.S.A. www.hds.com Regional Contact Information Americas +1 408 970 1000 [email protected] Europe, Middle East, and Africa +44 (0) 1753 618000 [email protected] Asia Pacific +852 3189 7900 [email protected] MK-90CRH019-01...