1. Manuals
  2. Brands
  3. Mitsubishi Electric Manuals
  4. Air Conditioner
  5. PURY-80TMU
  6. Service handbook

Mitsubishi Electric PURY-80TMU Service Handbook page 66

City multi
Hide thumbs
Table of Contents
(3) Investigation of transmission wave shape/noise
Control is performed by exchanging signals between outdoor unit, indoor unit and remote controller by M-NET
transmission. If noise should enter into the transmission line, the normal transmission will be hindered causing
erroneous operation.
1) Symptom caused by the noise entered into transmission line
Cause
Noise entered into
transmission line
2)
Method to confirm wave shape
Check the wave shape of transmission line with an oscilloscope to confirm that the following conditions are being
satisfied.
1 The figure should be 104μs/bit ± 1%.
2 No finer wave shape (noise) than the transmission signal (52μs ± 1%) should be allowed. *1
3 The sectional voltage level of transmission signal should be as follows.
Logic value
Transmission line voltage level
0
V
HL
1
V
*1 However, minute noise from the DC-DC converter or inverter operation may be picked up.
Signal changes and is misjudged as the signal of other
address.
Transmission wave shape changes to other signal due to
noise.
Transmission wave shape changes due to noise, and can
not be received normally thus providing no reply (ACK).
Transmission can not be made continuously due to the
entry of fine noise.
Transmission can be made normally, but reply (ACK) or
answer can not be issued normally due to noise.
V
HL
V
BN
52 μs
52 μs
52 μs
Logical
value "0"
Logical
= 2.0V or more
= 1.3V or less
BN
Erroneous operation
No fine noise allowed
52 μs
52 μs
value "1"
No fine noise allowed *1
–65–
Error code
6600
6602
6607
6603
6607
6608
*1
Table of Contents
loading

Related Manuals for Mitsubishi Electric PURY-80TMU

Related Products for Mitsubishi Electric PURY-80TMU

This manual is also suitable for:

Pury-100tmu-aCmb-104Cmb-105Cmb-106Cmb-108Cmb-1010 ... Show all

Table of Contents