Cisco ISB7105 Product Manual

Cisco ISB7105 Product Manual

Iptv receivers
Hide thumbs Also See for ISB7105:
Cisco
IPTV Receivers
Product Manual
ISB7105
For use with your AT&T U-verse TV service
Table of Contents
loading

Summary of Contents for Cisco ISB7105

  • Page 1 Cisco IPTV Receivers Product Manual ISB7105 For use with your AT&T U-verse TV service...
  • Page 3: Table Of Contents

    Front Panel ........................8 Back Panel ........................9 Connecting the Receiver ....................10 ISB7105 Wireless Network Connection .................11 Connecting the Wireless Access Point to the Gateway ............12 Pairing the Wireless Access Point and Receiver ............12 Connections for a High-De nition TV (HDTV) ..............13 Connections for a Standard-De nition TV (SDTV) ............14...
  • Page 4: Notice For Installers

    Notice for Installers The servicing instructions in this notice are for use by quali ed service personnel only. To reduce the risk of electric shock, do not perform any servicing other than that contained in the operating instructions, unless you are quali ed to do so.
  • Page 5 IMPORTANT SAFETY INSTRUCTIONS, continued Protect from Exposure to Moisture Ground the Product and Foreign Objects WARNING: Avoid electric shock and fire hazard! If this product connects to cable wiring, WARNING: Avoid electric shock and fire be sure the cable system is grounded (earthed). hazard! Do not expose this product to dripping or Grounding provides some protection against splashing liquids, rain, or moisture.
  • Page 7: Change The Way You Watch Tv

    Change the Way You Watch TV Welcome to Internet Protocol TV (IPTV). The ISB7105 device, known as an IPTV receiver, brings a rich, new set of interactive services directly to you through your TV and your in-home IP network. The receiver uses wireless technology 802.11n to connect to the network.
  • Page 8: Front Panel

    1 Power receiver, press and hold the POWER button for 10 seconds. The LED is green Identi es the model number of your receiver as ISB7105 2 Model Number Identi es the strength of the wireless connection 3 Signal Strength Indicator Indicates network link status.
  • Page 9: Back Panel

    Back Panel ® VIDEO AUDIO HDMI OPTICAL POWER NETWORK 1 Network Connect to the Ethernet (CAT-5) network at your home, if applicable 2 YPbPr Connect the receiver to the component video input (YPbPr) on the HDTV. See pages 13 and 14 for more information 3 Video Out Connect to composite input on your HDTV or SDTV 4 Audio Out (L/R)
  • Page 10: Connecting The Receiver

    Connecting the Receiver To connect your receiver to your network and home entertainment devices, complete these steps. Because the connections for a high-de nition (HD) or standard-de nition (SD) TV are di erent, you must determine if your TV is HD or SD.
  • Page 11: Isb7105 Wireless Network Connection

    AT&T U-verse Connection POWER LINK The ISB7105 receiver allows for easy and secure ISB7105 connection to IPTV services. The signal strength indicator on the front panel of the receiver identi es the strength of the wireless connection and aids in Signal Strength Indicator the proper placement of the receiver.
  • Page 12: Connecting The Wireless Access Point To The Gateway

    Connecting the Wireless Access Point to the Gateway RJ-45 1. Connect the 12 VDC Power Supply plug on Gateway Cable the access point to the wall power outlet. Ethernet Port Use only the power adapter provided with the product. 12VDC 2.
  • Page 13: Connections For A High-De Nition Tv (Hdtv)

    Connections for a High-De nition TV (HDTV) To use the receiver with an HDTV, you must make one of the following connections to view the HD content. Refer to the owner’s manual for your TV and the cabling diagrams in this manual for more detailed connection information. Although all connections provide you with quality service, we list the connections in our recommended order.
  • Page 14: Connections For A Standard-De Nition Tv (Sdtv)

    Connections for a Standard-De nition TV (SDTV) When using the receiver with an SDTV, you must make one of the following connections to view content. Some SDTVs may not have all these connections. Refer to the owner’s manual for your TV and the cabling diagrams in this manual for more detailed information.
  • Page 15: Connections For A Vcr Or Dvd Recorder

    Connections for a VCR or DVD Recorder When using the receiver with a VCR or DVD recorder, you must make one of the following connections to view content. Although all connections provide you with quality service, we list the connections in our recommended order.
  • Page 16: Connecting To An Hdtv With An Hdmi Connector

    Connecting to an HDTV with an HDMI Connector Cable Used in this Con guration • 1 HDMI Cable Notes: • The HDMI port on the TV must support high-bandwidth digital content protection (HDCP). • The HDMI interface supports Dolby Digital 5.1 audio. WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
  • Page 17: Connecting To An Hdtv With A Dvi Connector

    Connecting to an HDTV with a DVI Connector Cables Used in this Con guration • 1 HDMI-to-DVI Cable or 1 HDMI Cable and 1 HDMI-to-DVI Adapter • 1 Audio Left/Right Cable (You can also use an optical cable [indicated by the dotted line] instead of the Audio Left/Right Cable as shown in the diagram, dependent upon your TV’s capabilities.) Notes:...
  • Page 18: Connecting To An Hdtv With Component (Ypbpr) Connectors

    Connecting to an HDTV with Component (YPbPr) Connectors Cables Used in this Con guration • 1 Component Video Cable (YPbPr) • 1 Audio Left/Right Cable (You can also use an optical cable [indicated by the dotted line] instead of the Audio Left/Right Cable as shown in the diagram, dependent upon your TV’s capabilities.) WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
  • Page 19: Connecting To An Sdtv With Component (Ypbpr) Connectors

    Connecting to an SDTV with Component (YPbPr) Connectors Cables Used in this Con guration • 1 Component Video Cable (YPbPr) • 1 Audio Left/Right Cable Note: The receiver must be set to the proper standard-de nition mode. WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver.
  • Page 20: Connecting To An Sdtv With An Rca-Type Connector

    Connecting to an SDTV with an RCA-Type Connector Cables Used in this Con guration • 1 RCA-type Video Cable • 1 Audio Left/Right Cable WARNING: Electric shock hazard! Unplug all electronic devices before connecting or disconnecting any device cables to the receiver. Receiver ®...
  • Page 21: Connecting To A Home Theater System With Component (Ypbpr) Connectors

    Connecting to a Home Theater System with Component (YPbPr) Connectors Cables Used in this Con guration • 1 Component Video Cable (YPbPr) • 1 Audio Left/Right Cable (You can also use an optical cable [indicated by the dotted line] instead of the Audio Left/Right Cable as shown in the diagram.) Notes: •...
  • Page 22: Connecting To A Stereo Vcr Or Dvd Recorder (Optional)

    Connecting to a Stereo VCR or DVD Recorder (optional) The diagram below shows how to connect a recording device to your receiver. Although it is possible to watch TV using a connection through your VCR or DVD recorder to the TV, this connection may not provide the best picture, and HDTV users are restricted to an SD format.
  • Page 23: Troubleshooting

    Troubleshooting If the receiver does not perform as expected, the following tips may help. If you need further assistance, contact your service provider. No Picture • Verify that the power to your TV is turned on. • Verify that your wireless receiver and wireless access point are powered on. •...
  • Page 24: Frequently Asked Questions

    Frequently Asked Questions What Is Digital Television? Digital television (DTV) is a huge leap forward in television technology compared to analog television that has been widely available since the 1940s. DTV is delivered and displayed using digital encoding, similar to the way a PC operates. By using digital technology, there is no variation in picture and sound quality from the origination point until it is displayed on your television.
  • Page 25: Picture Formats

    Picture Formats What Is the Di erence Between a Standard-Screen and a Wide-Screen HDTV? The type of screen your HDTV has (wide-screen or standard-screen) determines how the receiver displays programs on the screen. The picture format for an HDTV is a combination of aspect ratio and screen resolution and is di erent for standard-screen and wide-screen HDTVs.
  • Page 26: Index

    Index AC Power input DC Power output Arrow keys Diagrams. See Connecting the receiver to other devices Aspect ratio Digital Video Recorder. See DVR Audio Out 9, 13, 14, 15 Digital TV, What is it DVD Connection 9, 10, 15, 22 Back panel DVI connector 13, 17...
  • Page 27 Index, continued Keys. See Front panel To TV (Video Out) connector 9, 14, 20 Troubleshooting Network 9, 10, 11 digital, what is it formats Optical Audio Output 9, 13, 17, 18, 21 HDTV, what is it Over-the-air converter box programming resolution screen size.
  • Page 28: Compliance Information

    Any changes or modifications not expressly may be required to obtain a separate use license approved by Cisco Systems, Inc., could void the from MPEG LA prior to any use of AVC/H.264 user’s authority to operate the equipment.
  • Page 29 The rmware setting is not accessible by the end user. ISB7105 with PCB antenna and max. antenna gain is 4.8 dBi in 5G. Industry Canada Statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
  • Page 30 Health Code 6 (2009) limits. The evaluation was based on evaluation per RSS-102 Rev 4. The minimum separation distance from the antenna to general bystander is 7.9 inches (20cm) to maintain compliance. Note: The ISB7105 has disabled the 5600-5650M band by S/W to avoid 5600-5650M band for IC certi cation.
  • Page 32 Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its a liates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company.

Table of Contents