Hitachi M 12SC Handling Instructions Manual
Router
Hide thumbs
Also See for M 12SC:
- Instruction and safety manual (68 pages) ,
- Technical data and service manual (40 pages)
Table of Contents
Quick Links
See also:
Technical Data and Service Manual
Table of Contents
Related Manuals for Hitachi M 12SC
Summary of Contents for Hitachi M 12SC
-
Page 1: Handling Instructions
Router Model M 12SC Handling instructions Note: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool. -
Page 2: General Safety Rules
A wrench or a key left attached to a rotating part of GENERAL SAFETY RULES the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance WARNING! at all times. Read all instructions This enables better control of the power tool in Failure to follow all instructions listed below may result in unexpected situations. -
Page 3: Specifications
PRECAUTIONS ON USING ROUTER Single-hand operation is unstable and dangerous. Ensure that both handles are gripped firmly during operation. The bit is very hot immediately after operation. Avoid bare hand contact with the bit for any reason. SPECIFICATIONS Voltage 230 V Power Input 900 W Collet Chuck Capacity... -
Page 4: Installing And Removing Bits
INSTALLING AND REMOVING BITS INSTALLING THE MOTOR HOUSING WARNING: WARNING: Be sure to switch power OFF and disconnect the plug Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble. from the receptacle to avoid serious trouble. 1. - Page 5 (3) Clamp the lever down until the point where a click can be felt. (Fig. 5) Template guide Template Knob nut Lever Fig. 7 Fig. 5 Secure the template to the workpiece. Feed the router NOTE: in the manner that the template guide moves along The motor housing can be temporarily secured by the template as shown in Fig.
-
Page 6: Maintenance And Inspection
Router feed 5. Service parts list CAUTION: Repair, modification and inspection of Hitachi Power Tools must be carried out by a Hitachi Authorized workpiece Service Center. Rotation of bit This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service Center when Fig. - Page 7 NOTE: Due to HITACHI’s continuing program of research and development, the specifications herein are subject to change without prior notice.
- Page 12 Hitachi Koki Co., Ltd. Code No. C99133011 Printed in China...