Table of Contents
Table of Contents
Related Manuals for Zanussi ZHT610X UK
Summary of Contents for Zanussi ZHT610X UK
- Page 1 User manual Cooker hood ZHT610X UK ZHT610W UK ZHT610N UK...
-
Page 2: For The Installer
If you require guidance in the use of the appliance or require further informa- tion on Zanussi Products, please contact our Customer Services Department. For general enquiries concerning your Zanussi appliance or for further information, visit our website at http:\\www.zanussi.co.uk... -
Page 3: Important Safety Information
It is dangerous to alter the specifications or modify this perienced persons may cause injury or more serious product in any way. malfunction. Refer to your local Zanussi Service Force Centre. Always insist on genuine spare parts. • When installed between adjoining wall cabinets the wall cabinets must not overhang the hob. -
Page 4: Your Appliance
YOUR APPLIANCE OPERATING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing. - Page 5 The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Recirculation In the recirculation mode contaminated air is passed through the charcoal filter to be purified and recirculated into the kitchen through a recirculation grille.
-
Page 6: Maintenance And Cleaning
MAINTENANCE AND CLEANING Before carrying out any maintenance or clea- ning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. -
Page 7: Changing The Light Bulb
Synthetic Paper Grease Filter The filter has saturation indicators, which are small squa- res made from a series of dots. When the white paper inside the squares becomes saturated with grease the coloured dots start to run and spread across the paper, indicating that the filter has reached saturation point and must be replaced. -
Page 8: Something Not Working
If you require an engineer or wish to purchase spare parts For general assistance with your appliance or for infor- contact your local Service Force Centre by mation on Zanussi products please contact our Customer telephoning: Services Department. Customer Services Department... -
Page 9: Guarantee Conditions
GUARANTEE CONDITIONS We Zanussi, undertake that if within 12 months of the date of the purchase this Zanussi built-in appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: •... -
Page 10: Installation Instructions
INSTALLATION INSTRUCTIONS It is dangerous to alter the specifications or attempt to modify this product in any way. Technical Information DIMENSIONS HEIGHT: 15 cm WIDTH: 59,8 cm DEPTH - VISOR CLOSED: 45 cm DEPTH - VISOR OPEN: 50,2 cm WEIGHT GROSS: 7,2 kg NET:... -
Page 11: Installing The Cooker Hood
INSTALLING THE COOKER HOOD Please ensure that when the appliance is installed it is easily accessible to an engineer in the event of a breakdown. All installations must comply with the local authorities requirements for the discharge of exhaust air. Incorrect installation may affect the safety of this cooker hood. -
Page 12: Wall Fitting
The clereance height between the inferior part of the cooker hood and the hob must be 650 mm ( some models can be fitted at a lower height from the hob, please refer to the installa- tion paragraph). Unpacking The fittings supplied to install this cooker hood can be found with the instruction book inside the packaging and consists of the following: Ducting spigot... - Page 13 Venting The hood is more effective when used in the extraction setting (ducted to the outside). Venting kits maybe purchased through your retailer or DIY store, and must be ducted to an outside vent of 100mm (4”) minimum. The ducting used must be manufactured from fire retardant material which should conform to the relevant British Standard or DIN4102-B1.
- Page 14 Wall Cabinet Fitting Before fitting the cooker hood beneath any type of wall The symbol on the product or on its packaging cabinet ensure it is firmly fixed to the wall in accordance indicates that this product may not be treated as household with the manufacturers instructions.
-
Page 15: Customer Care Department
Tel: + 353 (0)1 4090751 Email: [email protected] Customer Care Department For general enquiries concerning your Zanussi appliance or for further information on Zanussi products please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.zanussi.co.uk... - Page 16 U kan toebehoren, verbruiksprodukten en onderdelen bestellen via onze webwinkel op: www.zanussi.be Vous pouvez commander des accessoires, consommables et pièces détachées via notre magasin online sur: www.zanussi.be Voor het on-line bestellen van accessoires, consumables en onderdelen gaat u naar de ’webwinkel’ op: www.zanussi.nl...