Fujitsu Lifebook P7000 series Technical Procedures

Disassembly
Hide thumbs Also See for Lifebook P7000 series:

Quick Links

LifeBook P7000 Series
This LifeBook is also available in black, so the one you are working on may not be
the same color as the model shown here.
Be sure to power off the LifeBook before beginning this disassembly procedure.
1. Turn the unit over and remove the
battery.
3. Extract 2 screws from the RAM
cover and remove it.
Disassembly
2. Remove the optical drive.
4. Remove the RAM by pressing out
on the locking clips.
loading

Summary of Contents for Fujitsu Lifebook P7000 series

  • Page 1 LifeBook P7000 Series Disassembly This LifeBook is also available in black, so the one you are working on may not be the same color as the model shown here. Be sure to power off the LifeBook before beginning this disassembly procedure.
  • Page 2 5. Remove all 8 screws from the 6. Turn the unit over, open the cover lower case. and lay it flat. 7. Using a plastic screwdriver, pry up 8. Tilt up the keyboard, slide it and remove the speaker/status LED forward to release it, disconnect its cover.
  • Page 3 13. Lift off the display and set it 14. Use the plastic screwdriver to pry aside. off the palm rest 15. Disconnect the GlidePoint cable. 16. Turn the palm rest over and disconnect and remove the GlidePoint cable. 17. Remove 1 screw from the 18.
  • Page 4 21. Remove 13 screws from the 22. Disconnect the status LED cable, upper cover. remove the screw from underneath. 23. Lift off the top cover. 24. Remove 1 screw from the hinge switch, remove the tape from the status LED cable and lift them out. 25.
  • Page 5 29. Lift out the Expansion Card 30. Extract 2 screws from the Daughterboard. PCMCIA bracket and remove it. 31. Remove 2 screws from the Bay 32. Pry up the BIOS battery to Daughterboard and pull it up to remove it from the case and disconnect it from the system board.
  • Page 6 37. Remove 2 screws from the CPU 38. Turn the system board over, fan/heat sink, disconnect its cable remove 2 screws from the Expansion and remove it. Card Daughterboard cable and remove it. 39. Remove 1 screw from the Bay 40.
  • Page 7 45. Remove 4 screws from the LCD 46. Remove the tape from cable and tilt it up. and disconnect it. 47. Route the antenna cables out of 48. Remove one screw from each of the hinge cover. the 2 antennas, remove them, and disconnect their cables.