Table of Contents
Table of Contents
Related Manuals for GE Uninterruptible Power Supply
Summary of Contents for GE Uninterruptible Power Supply
-
Page 1: User Manual
USER MANUAL Uninterruptible Power Supply Line-interactive VCL Series UPS 400 – 600 – 800 – 1000 – 1500 VA GE Consumer & Industrial SA General Electric Company CH – 6595 Riazzino (Locarno) Switzerland T +41 (0)91 / 850 51 51 F +41 (0)91 / 850 52 52 www.gecriticalpower.com... - Page 2 User manual Uninterruptible Power Supply Line-interactive VCL Series UPS 400 - 600 - 800 – 1000 - 1500 VA Please read these instructions carefully before installation and start-up of the VCL Series UPS. Keep this manual in a safe place for future reference.
-
Page 3: Table Of Contents
Table of contents Page IMPORTANT SAFETY INSTRUCTIONS ............................4 SAVE THESE INSTRUCTIONS ..................................... 4 SAFETY RULES .......................................... 4 WARRANTY ..........................................5 STORAGE ............................................ 5 INSTALLATION & OPERATION ..............................5 INTRODUCTION ........................................5 INSTALLATION.......................................... 6 OPERATION ..........................................6 BATTERY REPLACEMENT PROCEDURE................................. 8 RECYCLING THE UPS AT THE END OF SERVICE LIFE .......................... -
Page 4: Important Safety Instructions
UPS. While every care has been taken to ensure the completeness and accuracy of this manual, GE accepts no responsibility or liability for any loss or damage resulting from the use of the information contained in this document. -
Page 5: Warranty
WARRANTY GE, operating through its authorized agents, warrants that the standard products will be free of defects in materials and workmanship for a period as per contract specifications. NOTE This warranty does not cover failures of the product which result from incorrect installation, misuse, alterations by persons other than authorized agents, or abnormal operating conditions. -
Page 6: Installation
INSTALLATION Connect the mains cord of the UPS to a working, grounded AC wall socket outlet. The unit will start automatically. For best results, allow the UPS to recharge the batteries during a period of approx. 8 hours. It is acceptable to use the UPS without first charging the battery, but the runtime may be reduced. - Page 7 RJ11 USB communication port The provided GE monitoring and shutdown software can be automatically configured to save your files and shut down your computer in the event of a prolonged power outage. Refer to the manual that came with the software.
-
Page 8: Battery Replacement Procedure
BATTERY REPLACEMENT PROCEDURE (Qualified service personnel only) Turn off the equipment that is connected to the output sockets of the UPS. Turn off the UPS. Unplug the UPS power cord from the AC wall outlet. Unplug the equipment from the output sockets of the UPS. Remove the 2 screws at the bottom side of the front panel (fig. -
Page 9: Recycling The Ups At The End Of Service Life
Proper disposal or recycling of the batteries is required. Refer to your local codes for disposal requirements! GE, in compliance with environment protection recommends that the UPS equipment, at the end of its service life, must be recycled conforming to the local applicable regulations. -
Page 10: Specifications
220x112x222 220x112x330 This document shall not be copied nor reproduced without the permission of GE. Due to technical improvements, some of the information contained in this manual may be changed without notice. © General Electric Consumer & Industrial SA. All rights reserved; reproduction without permission prohibited. The content of this manual may be subject to change without prior notice;...