GE 19200 Installation Instructions Manual

Wireless portable door chime kit

Quick Links

GE Model 19200
www.jascoproducts.com
Wireless Portable Chime
Installation Instructions for Wireless Portable
Door Chime Kit
Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips
screwdriver.
Included Hardware:
(2) 3x20mm screws
(2) Double sided adhesive pads
The portable wireless door chime Kit has two components:
Portable Chime (receiver)
Push-Button (Transmitter).
How To Install The Batteries
1. On the bottom of the portable chime you will find a round battery release
tab. Push the tab inward and slide the cover in the direction of the arrow.
The battery cover will slide off.
loading

Summary of Contents for GE 19200

  • Page 1 GE Model 19200 www.jascoproducts.com Wireless Portable Chime Installation Instructions for Wireless Portable Door Chime Kit Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips screwdriver. Included Hardware: (2) 3x20mm screws (2) Double sided adhesive pads The portable wireless door chime Kit has two components: Portable Chime (receiver) Push-Button (Transmitter).
  • Page 2 Battery Release Tab 2. Install 4 C-cell batteries (we recommend Alkaline Batteries) 3. Remove back of wireless push button and install the 12-volt battery (included) as shown below. Chime Tune Setting All wireless chimes may have more than one push button. The chime tune for each push button is set with jumpers 7-9.
  • Page 3 and 9=off.) 3. Select the desired chime sound from the table below. Chime Sound Table Position Westminster Ding Dong Knock Bronze Chime Cuckoo Clock Foghorn Gong ON: Add a jumper to a location OFF: Remove jumper from a location. 4. Remove or add the jumpers to match the table. 5.
  • Page 4 Each component has jumpers for setting the house security code: The chime and pushbutton must be set to the same house security code for the combination to operate together. Note : The push button has 3 additional jumpers that are used to set the chime tune that will play.
  • Page 5 3. Locate the House Security Code door and screw located on the back of the AC Chime. Remove the screw and take off the door. 4. Locate the chime and pushbutton jumpers shown below. Push Button Jumpers 5. Jumpers 1-6 are used to select 1 of 64 possible home security codes.
  • Page 6 Replacing the back cover 1. Push buttons are typically mounted at the same height as the door knob or handle (between 36" and 44" above the floor). 2. Before mounting, choose a mounting location that is not farther than 150...
  • Page 7 Not farther than 150 feet 3. Place the push button where you would like to mount it and with the chime as close to its final position as possible and test operation. If it works, mount the button. If it does not work, see TROUBLESHOOTING. 4.
  • Page 8: Operation

    7. Press front housing onto back cover. 8. Test operation. If the chime does not work, see TROUBLESHOOTING. Operation Slide power switch to “High” or “Low” to power the chime. Gently press transmitter button to sound chime. Troubleshooting Chime doesn't work: 1.
  • Page 9 For technical support contact Jasco Products Company at 1-800-654-8483 or www.jascoproducts.com Made in China is a trademark of General Electric Company and is used under license to Jasco Products Company LLC, 311 N.W. 122nd Street, Oklahoma City, OK 73114. www.jascoproducts.com Rev.