Bosch CCS 800 Ultro Installation And Operating Manual

Discussion system
Hide thumbs Also See for CCS 800 Ultro:
CCS 800 Ultro
Installation and Operating Manual
Discussion System
en
Table of Contents
loading

Summary of Contents for Bosch CCS 800 Ultro

  • Page 1 CCS 800 Ultro Installation and Operating Manual Discussion System...
  • Page 3: Table Of Contents

    CCS 800 Ultro | Installation and Operating Manual en | 3 Table of Contents 1. About this manual ................................5 2. Introduction ..................................5 3. Central Unit (CU) ................................6 4. Delegate and Chairman unit ............................7 5. Installation ..................................7 Connecting the delegate and chairman units ........................7 Connecting up to 150 units ..............................8...
  • Page 4 CCS 800 Ultro | Installation and Operating Manual en | 4 Bosch Security Systems B.V. | 2007-08...
  • Page 5: About This Manual

    About this manual Introduction This manual provides all the information required to The CCS 800 Ultro Discussion System is a discussion install and operate the CCS 800 Ultro Discussion system for use in meeting and conference venues with a System.
  • Page 6: Central Unit (Cu)

    CCS 800 Ultro | Installation and Operating Manual en | 6 Central Unit (CU) 5 Volume control of the speaker or headphone of the 6 Headphone connection with 3.5 mm stereo jack plug socket. 7 Trunk output 1 and 2. For loopthrough connection of the delegate and chairman units.
  • Page 7: Delegate And Chairman Unit

    CCS 800 Ultro | Installation and Operating Manual en | 7 15 Mains input connection. Use the included mains 9 Chairman Priority button. When pressed emits cord to connect the CU to the mains socket. chime tone, overrules/mutes all active microphones...
  • Page 8: Connecting Up To 150 Units

    | 8 5.2 Connecting up to 150 units The CCS 800 Ultro can be used with up to 150 units by adding a maximum of 2 additional control units acting as power supply units only. The cables necessary for these connections can be delivered by your local dealer.
  • Page 9: Connecting A Wireless Microphone

    CCS 800 Ultro | Installation and Operating Manual en | 9 5.5 Connecting a wireless Connect the cabling of the tape recorder (2) to the microphone recorder input and output of the CU (1). Use the gain control (3) to adjust the sensitivity of the recorder input of the CU.
  • Page 10: Connecting An Equalizer

    CCS 800 ULTRO isolation between the telephone network (PBX) and the CCS 800 Ultro system. The telephone coupler shall also meet all relevant requirements for this type of communication equipment as imposed by law and/or Figure 5.
  • Page 11: Operation

    CCS 800 Ultro | Installation and Operating Manual en | 11 Operation 6. 1 Testing the connection of the delegate and chairman units CCS 800 ULTRO Figure 6. 1 Put the mode selector in the test position, all light-ring indicators and LEDs of the delegate and chairman units must lit if properly connected.
  • Page 12: Using The Microphone Button Of The Chairman Unit

    CCS 800 Ultro | Installation and Operating Manual en | 12 6.3 Using the microphone button of the chairman unit 1...4 1...4 Figure 6.3 6.5 Priority mode settings in Pressing the microphone button on a chairman unit chairman unit always activates the chairman microphone, independent of the selected microphone mode.
  • Page 13: Open Mode

    CCS 800 Ultro | Installation and Operating Manual en | 13 6.6 Open mode Select the max. number ( 1, 2, 3 or 4) of delegate microphones which can be active at the same time. Note Chairmen can always switch on and off their microphones and are not included in the max.
  • Page 14: Override Mode

    CCS 800 Ultro | Installation and Operating Manual en | 14 6.8 Override mode CCS 800 ULTRO Figure 6.8 Each time a delegate presses the microphone button on a delegate unit, it will override the currently active delegate unit. So only one delegate microphone is active at the same time.
  • Page 15: Volume Control Of The Delegate And Chairman Units

    CCS 800 Ultro | Installation and Operating Manual en | 15 6. 1 0 Volume control of the delegate and chairman units CCS 800 ULTRO Figure 6. 1 0 Turn the volume control (1) to set the volume of the loudspeakers of the delegate and chairman units (2).
  • Page 16: Monitoring Volume Control

    CCS 800 Ultro | Installation and Operating Manual en | 16 6. 1 2 Monitoring volume control CCS 800 ULTRO Figure 6. 1 2 6. 1 3 Using a headphone Use the built-in loudspeaker or a headphone to monitor the discussion. Adjust the volume using the monitoring volume control.
  • Page 17: Built-In Mp3 Recorder

    CCS 800 Ultro | Installation and Operating Manual en | 17 Built-in MP3 recorder 7.2 Overview 7.2.1 User display 7. 1 Introduction The user display has five soft buttons for operating the The built in MP3 recorder allows users to: MP3 recorder (see following figure).
  • Page 18: Setting Up The Mp3 Recorder

    9 Total time: In record mode, shows the remaining After powering up the CCS 800 Ultro, the start-up time in hours, minutes, and seconds. The timer screen is briefly displayed, which shows the name of the counts down during recording;...
  • Page 19 CCS 800 Ultro | Installation and Operating Manual en | 19 7.3.1 Overview of set-up icons table 7.2: Overview of icons for navigating set-up screens Icon Icon name Function of icon Next (displayed at lower Go to next set-up screen. This icon is also displayed at the top left of...
  • Page 20: Setting The Date And Time

    CCS 800 Ultro | Installation and Operating Manual en | 20 7.3.2 Deleting files 7.3.3 Setting the date and time Use this option to delete files. Note To change settings in the set-up mode, you must 1 Press the up or down button to select the file to follow the programmed sequence of events delete.
  • Page 21 CCS 800 Ultro | Installation and Operating Manual en | 21 7.3.4 Selecting the bit rate 7.3.6 Set internal/ external recording options 1 Press the up or down button to change the value (bit rate). The following bit rates are available:...
  • Page 22: Record

    CCS 800 Ultro | Installation and Operating Manual en | 22 7.4 Record Use the record mode to record discussion. Before recording, make sure the SD card is inserted into the slot to the right of the display, or the unit is set to internal recording.
  • Page 23: Making A Recording

    CCS 800 Ultro | Installation and Operating Manual en | 23 7.4.2 Making a recording 7.4.3 Exchanging SD cards during recording Make a recording as follows: The SD card can be changed at any time during 1 Press the change mode button to select the record recording, but the new card must be inserted within one mode.
  • Page 24: Pre-Listen And Playback

    CCS 800 Ultro | Installation and Operating Manual en | 24 7.5 Pre-listen and Playback Pre-listen and Playback are almost the same. The difference between these two modes is described below: Pre-listen Use the pre-listen mode to listen to discussion before playing it back to the floor.
  • Page 25 CCS 800 Ultro | Installation and Operating Manual en | 25 7.5.2 Pre-listening to and playing back files To pre-listen to or playback files: 1 Press the change mode button (1) to select the required mode. The pre-listen or playback icon is shown in the top right-hand corner of the display, depending on the mode selected.
  • Page 26: Troubleshooting

    CCS 800 Ultro | Installation and Operating Manual en | 26 Troubleshooting Part of system not working • Possible cause Temporary no microphone reaction, and no sound or Interrupted trunk-line cabling. distorted sound from unit loudspeakers • Solution • Possible cause Check the trunk-line cabling connections between Trunk-line overload.
  • Page 27 CCS 800 Ultro | Installation and Operating Manual en | 27 Hourglass flashes very fast Recorded files missing on SD card • Possible cause • Possible cause The SD card was removed during recording. The SD card is full. •...
  • Page 28: Technical Data

    CCS 800 Ultro | Installation and Operating Manual en | 28 Technical data Recorder in/output (unbalanced) - mono Input sensitivity: - 20 dBV/ + 5 dBV (nominal/maximum) 9. 1 System Electrical and Electro- Input sensitivity Acoustical Characteristics adjustment: +0 / -20 dB Input impedance: 47 kΩ...
  • Page 29: Mechanical Data

    CCS 800 Ultro | Installation and Operating Manual en | 29 9.2 Mechanical Data Auto microphone switch-off function selectable on the Control and Power Supply Unit 9.2.1 Control and Power Supply Unit After approximately 30 sec. not speaking (sound level...
  • Page 30: General Data

    CCS 800 Ultro | Installation and Operating Manual en | 30 9.3 General Data 9.3.2Equipment Range Control and power 9.3.1 System Environmental Conditions supply unit: CCS-CU Temperature range CCS-CUD (with Digital Acoustic Storage and transport: -20 to +70°C (-4 to +158°F)
  • Page 31: Appendix

    CCS 800 Ultro | Installation and Operating Manual en | 31 10 Appendix 10. 1 Pin Configuration CCS 800 ULTRO Trunk in/out Microphone Recorder Line Telephone Insertion FIELD A Digital Acoustic Gain Gain Feedback Suppression 100-240 V~ Figure 10. 1 10.1.1Trunk Connections (A)
  • Page 32: Mounting Instructions

    CCS 800 Ultro | Installation and Operating Manual en | 32 10.1.5Headphone Jack-plug (3.5mm) (E) The CU can be attached in three different ways: 1 Tip - Signal + • In a 19" rack making use of the 19" rack mounting...
  • Page 33: Bracket For Flush Mounting

    CCS 800 Ultro | Installation and Operating Manual en | 33 10.3 Bracket for Flush Mounting The drawing below gives the necessary information how to make a bracket for flush mounting the CU into a table. 90˚ ø8.6(4x) 4.6 (2x) 50.3...
  • Page 34 CCS 800 Ultro | Installation and Operating Manual en | 34 Bosch Security Systems B.V. | 2007-08...
  • Page 36 For more information visit www.boschsecurity.com © Bosch Security Systems B.V. Data subject to change without notice 2007-08...

Table of Contents