Built-in power bank with usb outlet to charge mobile devices (32 pages)
Summary of Contents for Husqvarna EA 850
Page 1
Lir e attentiv ement et bien assimiler le and mak e sur e y ou understand them man uel d’utilisation a vant d'utiliser la bef or e using the machine . machine . EA 850 DGER ATTACHMENT CCESSOIRE TRANCHE BORDURE UPLEMENTO CORTABORDES Lea detenidamente el man ual de instrucciones y asegúr ese de entender...
For other procedures, please refer to the operating instructions for the machine. Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice.
SAFETY INSTRUCTIONS Machine′s safety equipment This section describes the machine′s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. See the ”What is what?” section to locate where this equipment is positioned on your machine.
SAFETY INSTRUCTIONS Personal protection • Always wear boots and other equipment described under the heading Personal protective equipment. • Always wear working clothes and heavy-duty long trousers. • Never wear loose clothing or jewellery. • Make sure your hair does not hang below shoulder level. Safety instructions regarding the surroundings •...
SAFETY INSTRUCTIONS Basic working techniques Safety instructions while working • Always ensure you have a safe and stable working position. • Always use both hands to hold the machine. Hold the machine at the side of your body. • Use your right hand to control the throttle setting. •...
Fitting the bevel gear Fit the bevel gear on the shaft. Turn the cutter so that the shaft engages in the bevel gear. Position the bevel gear so that the slot aligns with the line on the shaft. Firmly tighten the screw. ASSEMBLY Fitting the cutter Fit the cutter as follows:...
STARTING AND STOPPING Starting and stopping Check before starting • For safety reasons follow these recommendations! • Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked. •...
However, before using the machine you should check that the bevel gear is filled three-quarters full with grease. Use HUSQVARNA special grease. The grease in the bevel gear does not normally need to be changed except if repairs are carried out.