Craftsman 139.30499 Instructions

Compatible with 315 MHz or 390 MHz

garage door openers manufactured after

January 1, 1993. Make sure the garage

door opener has a working light bulb

because it is a programming indicator.

PREPARE

PROGRAM THE REMOTE CONTROL

1

To enter programming

mode, press the Program

button until the LED on the

front of the remote control

turns on.

Safety Pin or

Paper Clip

4

To exit programming mode, press

any remote control button except

the button that was just programmed.

BATTERY

The LED on your remote will

stop flashing when the

battery is low and needs to

be replaced.

To replace battery, open the

case as shown. Insert

battery positive side up (+).

Replace the battery with

only 3V2032 coin cell

batteries. Dispose of old

battery properly.

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:

• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play

with remote controls.

• Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no

obstructions to door travel.

• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross

path of moving gate or door.

OR

Learn

LED

Learn

LED

Green or

Purple

Red/Orange

2

Press and release the

Learn button on

the garage door

opner.

The Learn LED will light.

Within 30 seconds...

5

To test, press the programmed button on the remote control...

To prevent possible SERIOUS INJURY or DEATH:

• NEVER allow small children near batteries.

• If battery is swallowed, immediately notify doctor.

To reduce risk of fire, explosion or chemical burn:

• Replace ONLY with 3V2032 coin batteries.

• DO NOT recharge, disassemble, heat above 212° F

(100° C) or incinerate.

Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10A20

3-BUTTON REMOTE CONTROL MODEL 139.30499

Locate the Learn button on

the garage door opener.

NOTE: Your garage door

opener may look different.

OR

Learn

LED

Yellow

3

Press and release the remote

control button you want to use...

Check to see if the garage door opener

light bulb blinks. If not, wait for the

remote control LED to light solid then

slowly press and release the remote

control button again. Repeat until the

light bulb blinks.

DO NOT press the button after the

light bulb blinks.

Locate the Program button on

the remote control

.

Program Button

The garage door opener

will activate.

NOTICE: To comply with FCC and or Industry

Canada rules (IC), adjustment or modifications

of this receiver and/or transmitter are prohibited,

except for changing the code setting or

replacing the battery

THERE ARE NO OTHER USER SERVICEABLE

PARTS.

Tested to Comply with FCC Standards for Home

or office use. Operation is subject to the

following two conditions: (1) this device may

not cause harmful interference, and (2) this

device must accept any interference received,

including interference that may cause undesired

operation.