1. Manuals
  2. Brands
  3. D-Link Manuals
  4. Firewall
  5. DFL-1000
  6. Quick install manual

D-Link DFL-1000 Quick Install Manual

Hide thumbs Also See for DFL-1000:
1
2
3
4
5
6

Quick Links

Important Information
Before you begin installing your new DFL-1000 you must have:
1.1 Internal IP Address:
1.2 Internal Netmask:
1.3 External IP Address:
1.4 External Netmask:
1.5 Default Gateway Address:
1.6 DMZ IP Address:
1.7 DMZ IP Netmask:
•
Default Gateway Address, External IP and Netmask will be supplied by your
Internet Service Provider.
•
DMZ Address and Netmask are only needed if DMZ will be used.
Checking The Package Contents
Includes Power Cord, 1 Crossover Ethernet Cable (blue), 1 Straight Ether-
net Cable (grey),1 Null-Modem Serial Cable, User Manual and
QuickStart Guide.
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
_____._____._____._____
loading

Related Manuals for D-Link DFL-1000

Summary of Contents for D-Link DFL-1000

  • Page 1 Important Information Before you begin installing your new DFL-1000 you must have: 1.1 Internal IP Address: _____._____._____._____ 1.2 Internal Netmask: _____._____._____._____ 1.3 External IP Address: _____._____._____._____ 1.4 External Netmask: _____._____._____._____ 1.5 Default Gateway Address: _____._____._____._____ 1.6 DMZ IP Address: _____._____._____._____ 1.7 DMZ IP Netmask:...
  • Page 2 2. Using command line interface: • Connect one end of the null-modem serial cable to the Console connector at the front of the DFL-1000 and connect the other end to the serial port of an administration computer or terminal. •...

  • Page 3: Setting The Ip Addresses

    dows operating system. • For the terminal port parameters set Bits per Second to 115200, Data bits to 8, Parity to None and Stop bits to 1. • At the Login prompt type admin, no password required. • Follow the instructions in the next section to set the interface addresses. Setting the IP Addresses First set the internal interface address to be in your internal network.

  • Page 4: Connecting To Your Network

    In the event of difficulties you can restore the factory default settings with the following command: • set system status reset When you are finished with the console you can log out using the com- mand: • quit Connecting to Your Network Connect the Internal Interface to an Internal Network Hub or Switch using a straight Ethernet cable.The Link indicator will light up if the connection is to a 100 megabit device.

  • Page 5: Advanced Configuration

    DFL-1000 External Interface to the Public Switch or Router provided by your Internet Service Provider. Advanced Configuration Now that you have completed the basic network setup, the DFL-1000 should be operating with the default policy, which is to allow all traffic origi- nating from Internal to reach outside, and deny all traffic originating from the Internet.
  • Page 6 From the web-based manager: 1. Go to System > Status. 2. Click Reset to default and click OK. The DFL-1000 is returned to the configuration that it had when you first switched it From the CLI: 1. Enter the command.