Related Manuals for Hitachi CM-N28000BF
Summary of Contents for Hitachi CM-N28000BF
-
Page 5: Safety Precautions
English Safety precautions Precautions described here are intended for safe and correct use of this product and are to prevent injury and damage to you and others before they occur. Precautions are classified as follows. Make sure to observe the precautions because they are all important in relation to safety. Indicates an imminently dangerous situation in which improper handling may result in death or serious injury to a user. - Page 6 Do not use this product on the following regions. (Cause of accident or trouble) - Regions where orthopedic treatment was given - Eyeballs and upper eyelids - Wound sites - Facial melanoderma - Mucosal regions, such as inside the mouth - Regions irritated due to pimples or skin rash - Lips - Regions which suffer from sensation of pain or perception disorder...
- Page 7 Do not insert or remove the power plug in/from the outlet with wet hands. (Cause of failure or short circuit) Prohibited Do not wash or splash water on this product. (Cause of failure or short circuit) Do not use or keep this product in places easily splashed with water or in Prohibited damp places, such as in a bathroom.
-
Page 8: Preparation Before Use
Names of parts and their functions (Fig. 1) Heating head (titanium material) Buzzer (Switching sound/ready Attach cotton and apply it to your skin. sound/warning sound/finish sound) The device vibrates while being used in Every time the switch or button is modes other than “Cool.”... - Page 9 2 Clean skin by washing your face so that makeup and dirt will wash off. Wipe off makeup with a cleansing product. 3 Attach cotton to the body of the device. (Fig.2) Cotton The narrower side of the inner circumference should be upward. (1)Remove the protection seal from the heating head.
-
Page 10: How To Use
Example for use Press the mode switch button and set the mode of your preferred treatment. Quick tighten-up treatment (Required time: approximate 2 minutes) Step 4 “COOL” When you want to tighten your pores or cool down your skin before applying make up, you can just use “COOL.”... - Page 11 Do not use the product around eyes and ears. (Cause of accidents or bad physical condition) If you feel something is unusual with your skin or body while using the device, stop using it immediately and consult a skin care specialist. (Cause of accident or poor health) Step 1 "HOT CLEANSING"...
- Page 12 Add more toner when there is no moisture in the cotton or when the device is difficult to slide. Do not apply the device on the same area of skin for more than 10 seconds. If you feel your skin tingling by micro current while using the device, press the level switch button and switch to "Low."...
- Page 13 CAUTION Unless you apply cotton puff to your skin while touching the back plate, the device will not vibrate. (skin sensing function) If the heating head is not vibrating, the device is not working. If you leave the device as it is for about 3 minutes without vibration, the device will automatically switch "Off."...
- Page 14 4 Hold the device with your hand touching the back plate of the body. (Fig. 5) Make sure to hold the body with your hand touching the back plate. 5 Apply the heating head directly to the skin and move it slowly. (Fig. 6) The mode indicator lamp will switch and turn on, and the device will start to vibrate.
- Page 15 3 Choose "the strength" of electrical potential with the level switch button. Switch the "strength" with the Level switch button according to the condition of your skin. Every time the level indicator button is pressed, the high, medium, and low of the electrical potential will be switched.
- Page 16 1 After confirming that the power adaptor is connected to the main body, press the power switch. (Fig.11) “Low” on the level indicator lamp lights and “ ” on the mode indicator lamp starts COOL flashing. If a lamp in another mode is flashing, press the mode switch button to switch to “...
-
Page 17: Specifications
Care for main body Wipe off the toner on the head and the body with a tissue. When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and wring it thoroughly. Do not clean the main body with water. Or do not dip in water, and do not pour water. - Page 18 CAUTION Make sure to pull out the device plug from the main body after using. Do not store it when the power adaptor is connected with the main body or the cord is wound around the main body. (Result in damage of the cord) Cord Do not wind the cord around the main body.
- Page 19 NOTICE Attention for Use Make sure to hold the main body of the product with your hand touching back plate and apply the head of the product to your skin. Otherwise, the product will not be operated. Back plate About Skin Testing Function This product which is operated through the human body.
- Page 20 FAQs Questions Answers Check the intensity level. If it is set on "High" level, Tingling sensation is felt on the skin. press the level switch button to switch to "Low" level. If toner in the cotton pad wears off, replenish it again. If you still feel uncomfortable on the skin, stop using the product immediately and consult a dermatologist.