Quick Links
See also:
Service Manual, User Manual
Register your product and get support at
ENG
Quick Start Guide
© 2009 Koninklijke Philips Electronics N.V.
All rights reserved.
CEM210_51_UM_V1.1
CEM210
1
a
b
c
e
f
g
2
3
4
a
c
AMP
b
Overview of parts 1
For cars without ISO connectors
These are the supplied parts needed to connect
and install this unit:
Caution
In-car audio system
a
Be sure to connect the black ground (earth)
•
Sleeve
b
lead first.
Front panel
c
ISO connector
d
1
Connect the antenna and amplifier as
Trim plate
e
illustrated, if applicable.
Rubber cushion
f
2
Cut off the bigger end of the supplied
Disassembly tools
g
standard connector.
Screws (4 pieces)
h
3
Check the car's wiring carefully and connect
them to the supplied standard connector.
Connect wires
4
Connect the supplied standard connector to
the unit.
Caution
1
Green/black strip Left speaker (Rear)
•
Ensure that all loose leads are insulated with
2
White/black strip Left speaker (Front)
electrical tape.
3
Gray/black strip
4
Purple/black strip Right speaker (Rear)
For cars with ISO connectors
2 3
1
Pull out the ISO connectors from car
e RED
dashboard and connect them to the bigger
end of the supplied standard connector.
f BLUE
2
Connect the other end of the supplied
standard connector to the unit.
3
Connect the antenna and amplifier as
g BLACK
illustrated, if applicable. You can connect the
h Orange
car audio to the amplifier through RCA-TO-
i YELLOW To the +12V car battery which is
RCA cables (not supplied).
Connector
Connect to
Note
1
ANTENNA
Antenna
•
Check wire connection before you mount the
2
REAR LINE OUT R
Rear right speaker
unit into a car.
3
REAR LINE OUT L
Rear left speaker
•
If preset radio stations are lost when the
ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to the
yellow ones.
5
d
h
a
a
a
b
c
d
a
b
b
b
c
d
e
c
c
f
g
h
i
d
d
Attach the front panel 5
3 4
1
Attach the trim plate.
2
Insert the right side of the panel in the
chassis until it is correctly engaged.
3
Press the left side of the panel and point the
left hole at the left pillar.
4
Release the panel to engage the left side.
Mount in the dashboard 5
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car battery.
•
If you disconnect the car battery in a car
that has an on-board drive or navigation
computer, the computer may lose its
memory.
•
If the car battery is not disconnected,
Right speaker (Front)
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Remove the two screws on the top of the
unit.
Ignition key +12V DC when
3
ON/ACC
Remove the mounting sleeve with the
supplied disassembly tools.
Motor/electric antenna relay
control lead/Amplifier relay
4
Ensure that car dashboard opening is within
control lead
these measurements:
Ground
5
Install the sleeve into the dashboard and
Illumination switch
bend the tabs outward to fix the sleeve.
6
Place the supplied rubber cushion over the
energized at all times
end of the mounting bolt.
7
Slide the unit into the dashboard until you
hear a click sound.
8
Reconnect the negative terminal of the car
battery.
Turn on
Listen to radio
1
1
Press z to turn on the unit.
Press SOURCE repeatedly to select Tuner.
•
To turn off the unit, press z for 3
2
Press 3 or 4 to select band: [FM1], [FM2],
seconds.
[FM3], [AM1], or [AM2] .
3
Press ∞ or § to tune to a radio station
Set clock
manually.
1
•
To search for a radio station
Press MENU/DISP for 3 seconds.
automatically, press
2
Press 3 or 4 repeatedly to until the
seconds.
currently time is displayed.
3
Turn z clockwise to set hour.
Play audio files
4
Press z to confirm.
1
Press
on the front panel to release the
5
Turn z anti-clockwise to set minute.
panel.
2
6
Press z to confirm.
Insert a CD with the printed side facing up.
3
Close the panel.
View clock
Play starts automatically.
»
•
To pause CD play, press 1
1
Press MENU/DISP repeatedly until the clock
•
To resume CD play, press
is displayed.
Insert the USB device
1
Open the cover marked
panel.
2
Insert the USB device into the USB socket.
The unit star ts playing from the USB
»
device automatically.
or
for 3
.
1
again.
on the front
