Bbu Module Led; Psu Leds - Bosch DVA-12T Installation Manual

24

en | Subsystem Monitoring

Speed LED

Status LED

Table 4.4 LAN Port LED Definitions

4.2.5

The BBU module has an LED on the right side of the rear panel. (See Figure 4.4) The function

is the same as the sixth LED on the controller module. The LED is off when the BBU is func-

tioning normally and is able to sustain the cache memory. The LED flashes to indicate the BBU

is charging. If the LED is illuminating amber, please re-charge the BBU or contact your system

vendor to verify the problem.

Fig. 4.4 BBU Module LED

4.2.6

Each PSU comes with a single LED at the back (see Figure 4.5), located just above the power

switch that turns on the subsystem. This LED indicates the operational status of the PSU mod-

ule. Please refer to the PSU LED definitions shown in Table 4.5.

Fig. 4.5 PSU Module LED

Flashing Green The power supply has not been turned on. The PSU module LED will blink

Static Green

Static Red

OFF

Table 4.5 PSU Module LED Definitions

F.01U.027.798 | V1 | 2006.06

Name

Color

Green

ON indicates the connection speed is running at 1Gigabit per

second

OFF indicates the connection speed is running at 10/100Mb per

second

Green

ON indicates currently connected to a LAN

FLASHING indicates active transmission

Color

when the subsystem is connected to a power source but not yet turned on.

The PSU is operating normally and experiencing no problem.

The PSU has failed and is unable to provide power to the subsystem.

The PSU is not turned on. The PSU module LED will remain off even if the

power cable has been plugged in but the power switch is not turned on.

RAID Subsystem DVA-12T | Installation Manual

Status

Status

Bosch Security Systems