IMPORTANT:
Read and save these instructions.
Washer & Dryer Pedestal
Kit
This kit is intended
to be installed by persons having
electrical and mechanical
training and a
level of knowledge
considered
acceptable
in the appliance
repair
trade.
Your safety and the safety of others are very
important.
Many important
safety messages
are
provided
in these instructions
and on your
appliance.
Always read and obey all safety
messages.
EXCESSIVE
WEIGHT
HAZARD
Two or more people
may be required
to move
and
install
the washer
& dryer with pedestals.
Failure
to comply
may cause
back or other
injury.
Tools needed:
Level
9/16" open end wrench or ratchet
Channel-lock
adjustable pliers
2# Phillips screwdriver
Flat blade screwdriver
WASHER
INSTALLATION
Washer
Hardware
.
.
.
.
.
.
Remove the 24-3/8" x 27" x 12"pedestal,
installation
hardware
and instructions
from the
shipping carton.
Using the pedestal shipping carton for
protection,
carefully lay the washer on its back.
NOTE:
If washer was previously
installed,
disconnect
from power supply, remove inlet
hoses from water faucets and tape the drain hose
to the top front of the washer to eliminate excess
water on the floor.
Remove the four (4) leveling legs from the
washer base and discard.
If the washer has rollers, remove the four (4)
screws securing the rollers to the base.
Install the four (4) leveling legs (supplied with
the kit) fully into the pedestal.
The words "TOP FRONT" are embossed
on the
top front of the pedestal. Position the pedestal so
the words are up with the front of the washer.
Align the pedestal mounting
holes with the
threaded leg holes on the washer base.