RCA DH93RF User Manual

This RF Modulator Kit includes everything you need to convert the separate audio and video

signals (from a video camera, computer, portable VCR, or satellite receiver, for example) into an

RF TV signal that you can view through the RF jack on your TV set.

What's included

In addition to the RF Modulator, this kit has the following

cables for connecting your component and your TV:

• 1 3FT. Audio/Video Cable

• 1 3FT. Coaxial Cable

These are all the cables you need for a basic connection.

Depending on the connections offered by your TV and your

input component, you might also want to use the following

accessories:

• 1 S-Video Cable (not included)

• 1 75-ohm to 300-ohm matching transformer (not

included)

Installation

You can seat the RF modulator either vertically or horizontally.

To seat the RF Modulator vertically :

Slide the seat plate (included)

onto the bottom of the RF

Modulator until the locking

tab of the seat plate clicks in

to secure the plate to the RF

Modulator.

Note: To remove the seat plate

once you've seated the RF

Modulator, pull up the locking

tab on the bottom of the plate

and push the seat plate off of

the RF Modulator.

RF Modulator Kit

with S-Video Input

DH93RF User's Manual

Consulte el reverso para instrucciones en español

The FCC Wants You to Know

This device complies with Part 15 of FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may

cause undesired operation.

Your modulator might cause TV or radio interference even when is operating

properly. To determine whether your modulator is causing the interference,

turn it off. If the interference goes away, your modulator is causing it.

Try to eliminate the interference by:

• moving your RF Modulator away from the receiver

• connecting your RF Modulator to an outlet that is on a different

electrical circuit from the receiver

• contacting your local store for help

If you cannot eliminate the interference, the FCC requires that you stop

using your RF Modulator.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's FCC authorization to operate this equipment.

Note to the CATV System Installer: This reminder is provided to call

the CATV system installer's attention to article 820-22 of the NEC that

provides guidelines for proper grounding and, in particular, specifies that

the cable ground shall be connected to the grounding system of the

building, as close to the point of cable entry as practical.

To seat the RF Modulator horizontally :

Attach the four self-adhesive rubber pads (included) to

the side face of the RF Modulator.

Then, turn the RF Modulator onto the side with the

rubber pads.