Quick Links
Owner'sGuideto installation and Use
Model 9521A Drive and Controller,
117 VAC
Model 9521EU Drive and Controller, 230 VAC
Model 9537A Controller
Only, 117 VAC
Model 9537EU Controller
Only, 230 VAC
CAUTION:
Read
and
adhere
to all
IMPORTANT
SAFEGUARDS
listed
elsewhere
in this
booklet.
Read
and observe
safety,
installation
and operating
instructions
supplied
with
this unit and with your
antenna
BEFORE
installation
or operation.
Retain
this booklet
and
all instructions
for your safety
and future
reference.
Controller
Compatibility
- If purchased
separately,
the Model
9537
controller
may be used
with the
following
rotator
drive
units:
Channel
Master e-
Models
9500,
95!0(A),
95t2,
9513,
9515(A)
Radio
Shack _ -
Model
15-1225
If you
are
upgrading
an existing
installation
with
Model
9537
controller,
skip
to "Model
9537
Programmable
Controller"
in this leaflet°
Drive Unit Installation
STEP
1 -
Determine
proper
size
number
of rotator
cable
from
chart.
Three
conductor
cable
is
suitable,
but if four conductor
cable
is used,
connect
both conductors
3 and 4 to terminal
3 of the
terminal
board.
Gage
AVVG
MM
22
0,6
22
0,6
20
0,8
20
0,8
t8
! ,0
18
i_0
No. of
Maximum Length
Conductors
Feet
Meters
3
180
55
4*
200
61
3
280
85
4*
310
95
3
445
I36
4*
510
I55
*Attach
3 and 4 conductors
to No. 3 terminals
on control
and drive°
STEP 2 - Install drive unit. On new drive units, arrow on mast support
should be aligned with arrow shaped
mast stop on housing.
Install drive unit with arrows pointing
south.. Using a short piece of mast (3 feet or
less), install the antenna
to the drive unit aiming the antenna
south,. When desired
channels
are close to or
on opposite
sides of the north end stops, the antenna
may be installed
pointing
north,. Note, however, that
the antenna
will then be pointing
in the opposite
direction
from that indicated
on the control..
An alternative
means of setting up is to perform a synchronization
of the drive unit using the controller_ Then
set
up
the
antenna
pointing
north..
Ensure
power
is
disconnected
from
the
controller
when
making antenna
adjustments.
Related Manuals for Pioneer 9537EU
Summary of Contents for Pioneer 9537EU
- Page 1 Owner'sGuideto installation and Use Model 9521A Drive and Controller, 117 VAC Model 9521EU Drive and Controller, 230 VAC Model 9537A Controller Only, 117 VAC Model 9537EU Controller Only, 230 VAC CAUTION: Read adhere to all IMPORTANT SAFEGUARDS listed elsewhere in this booklet.
- Page 2 Loop to allow full turn of antenna . Mount antenna as close to rotor as possible. Use no more than 3 feet of mast in top of drive unit,, Do not mount citizens band base station antennas on top of a standard mast mount drive unit.
- Page 3 Remote Control - Use with supplied handheld unit or most universal handheld controllers configured as a Pioneer s Cable Box (HH1) or Pioneer s CD Player (HH2). Compatible with most DIRECTV s and Dish NetworkS universal hand- held remote controls°...
-
Page 4: Controller Installation
Controller Installation and Setup Important Note! Before disconnecting old control box, make note of each wire color and the corresponding terminal connection. Caution - To reduce the risk of electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to qualified service... -
Page 5: Operation
Operation From The Supplied Handheld Remote 1o Install 2 AM batteries in the handheld remote° 2o Check operation by pressing the POWER button and observing the display If it does not function, check for HH! in power up diagnostic display.. If the display is HH2, refer to Appendix A to change,... - Page 6 Pioneer ® brand cable converter boxes (HH1 mode) or most Pioneer _ brand CD players (HH2 mode). See Appendix A.. Refer to the instructions supplied with the universal remote control.
- Page 7 DOES NOT OPERATE CERTAIN FUNCTIONS (eg. UP/DOWN) If supplied remote control is OK, try all available Pioneer e cable box and Pioneer s CD player codes. Universal remote may not be fully compatible° UNIT DOES NOT TRACK CORRECTLY Check power...
- Page 8 IMPORTANT SAFEGUARDS Your antenna rotator unit, consisting of a control and a drive, has been engineered and manufactured to assure your personal safety, but improper installation or abuse of this unit, or the antenna connected to it, can result in potential electrical shock or fire...
- Page 9 8oAll individuals,especiallychildren, should be cautionedabout dropping or pushingobjectsinto any openings,Some internal parts carry hazardousvoltages and contact can result in electrical shock. Objects dropped into the control may also result in a fire hazard. 9oNeverexpose the controlto rain or water.It the control becomesdampor wet, or if liquidsare spilled into it, unplug the control and have it inspected by a service technicianbeforefurther use.
- Page 10 Chenne] M as_er D epartameelo de Venlas paredadlicad_n DIRECTV" _sa teg}st_md ltadomark or Hughes Communtcalions. Dish N_%workis a rogtstct_d trademark of Echostar Communi_tions, Pioneer is a registered trademark of Pion_._r E!eclmnics. Radio Shack is a registered Iradamazk of Tandy Carpoml_on ©2003 Channel Master LLC (8000869_0t)