Quick Links
•
15307
SWITCH:
CONTACT RATINGS:
TIMING MOTOR:
POWER CONSUMPTION: 3 WATTS MAX
For seperate motor terminals, remove bridge from terminals L & 1
L
H
H
TYPICAL FOR 277V SUPPLY
208-277VAC/60Hz
We recommend that installation be made by a licensed electrician.
Disconnect power at main panel prior to installing or servicing this
time switch or the equipment connected to it.
Connect in accordance with national and local electrical codes.
Supply Connections: Use gauge specified (AWG #8-14 ) suitable for 75
(167
F). Replace insulator before turning on electricity to unit.
º
INSTALLATION AND OPERATING INSTRUCTIONS TO SET ON AND
OFF TIMES:
Light trippers turn ON.
Dark trippers turn OFF. Place tripper on
dial edge as shown in figure and set
point of each tripper to desired oper-
ating time. Note if selected time is AM
or PM. Hold tripper against dial edge
and firmly tighten knurled screw.
INSTALLATION AND OPERATING INSTRUCTIONS
TO SET DIAL TO TIME:
Turn dial counter-clockwise until correct time is indicated by
arrow on nameplate.
FOR TEMPORARY MANUAL OVERRIDE:
Press down lever on right of nameplate to turn ON. Press down
lever on left of nameplate to turn OFF. CAUTION: Do not rotate
dial for manual override.
TO REMOVE MECHANISM FROM CASE:
Press lever near case latch to release mainplate and swing the
movement out. To replace, insert mainplate projections in slots
opposite latch and swing movement in until it latches.
15307
MANUAL VERSION 1
02/02/10
WWW.JASCOPRODUCTS.COM
HEAVY DUTY
MECHANICAL
TIME SWITCH
24 HOUR TIME SWITCH
DPST
40 AMP 120-277VAC
40 AMP TUNGSTEN 120VAC
20 AMP INDUCTIVE
208-277VAC 60Hz
M
1
X
LOAD
MUST BE
SAME PHASE
2
TYPICAL FOR 277V SUPPLY
OFF TIME
(Dark Tripper)
MANUAL
OFF
LEVER
1000VA (120-277) PILOT DUTY
120-277VAC SINGLE PHASE
2HP 120VAC; 5HP 240VAC
M
L
1
H
H
N
Typical for double pole
Cut motor lead at 1
Dial Calibrations
Knurled Screw
O
F
F
GE5361-41K2
X
2
LOAD
LOAD
C
º
ON TIME
(Light Tripper)
MANUAL
O
ON
N
LEVER
469D
