Honeywell H8908ASPST - Manual Humidistat Control Installation Instructions Manual

Honeywell H8908ASPST - Manual Humidistat Control Installation Instructions Manual

Humidistat/dehumidistat
Available languages

Available languages

H8908A/B Humidistat
H8908C/D Dehumidistat

APPLICATION

The H8908 family of low-voltage humidistats/
dehumidistats provide accurate control of whole house
humidifiers, dehumidifiers, and ventilators. They have a
snap-acting, dust-proof SPST switch and can be
mounted to a duct or wall.

Before Installing this Product...

1. Read these instructions carefully. Failure to follow
them could damage the product or cause a hazard-
ous condition.
2. Check the ratings given in the instructions and on
the product to make sure the product is suitable for
your application.
3. Installer must be a trained, experienced service
technician.
CAUTION
Personal Injury Hazard.
Power supply can cause electrical shock.
Disconnect power supply before beginning
installation.
NOTE: The H8908 electrical connections are not
shared with the thermostat.
INSTALLATION INSTRUCTIONS
Fig. 1. H8908A,D control.
CASE REMOVAL
HOLE FOR WIRING
SLOT
THE DUCT MOUNTING
INSTALLATIONS
Fig. 2. H8908B,C control.
M24726
M13371
69-1341EF-01
Table of Contents
loading

Summary of Contents for Honeywell H8908ASPST - Manual Humidistat Control

  • Page 1 H8908A/B Humidistat H8908C/D Dehumidistat INSTALLATION INSTRUCTIONS APPLICATION The H8908 family of low-voltage humidistats/ dehumidistats provide accurate control of whole house humidifiers, dehumidifiers, and ventilators. They have a snap-acting, dust-proof SPST switch and can be mounted to a duct or wall. Before Installing this Product...
  • Page 2: Duct Installation

    H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT DUCT INSTALLATION REMOTE MOUNT INSTALLATION 1. Choose a location on the duct. 1. Choose a location in the living area. NOTE: Select a location clear of drafts or excessive ALTERNATE LOCATION humidity. Avoid mounting near doors or win- dows, or in bathrooms or kitchens.
  • Page 3 H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT 4. Remove the base bracket from the humidistat. For duct mount, slide the black gasket onto the base bracket. See Fig. 8. NOTE: Use gasket only when mounting the control to ductwork. Leave off when mounting to a wall. M24733 Fig.
  • Page 4: Wiring

    H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT WIRING H8908 CAUTION Personal Injury Hazard. Can cause electrical shock and injury. POWER (HOT) FAN CONTROL Disconnect power before installation or servicing. SUPPLY All wiring must comply with applicable local codes, TRANSFORMER ordinances and regulations. Make wiring connections FURNACE according to humidifier (or dehumidifier/ventilator) MOTOR...
  • Page 5 H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT H8908 H8908 SAIL FAN WIRING SWITCH TERMINALS SYSTEM HUMIDISTAT TRANSFORMER TERMINALS HUMIDIFIER 24V WIRING. NOTE: FOLLOW THE INSTALLATION INSTRUCTIONS (HOT) HUMIDIFIER INCLUDED WITH THE STEAM HUMIDIFIER TO WIRE THE SYSTEM FAN. POWER SUPPLY. PROVIDE DISCONNECT MEANS M24731 AND OVERLOAD PROTECTION AS REQUIRED.
  • Page 6: Checkout

    H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT CHECKOUT OPERATION Turn the H8908 dial to “ON” to test proper installation. Humidity Control Adjustment See Fig. 20. To maintain optimal humidity levels without causing You will hear an audible click if installed correctly, and condensation on cold surfaces such as windows, the water will begin flowing to the humidifier.
  • Page 7 H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT 69-1341EF—01...
  • Page 8 H8908A/B HUMIDISTAT H8908C/D DEHUMIDISTAT Automation and Control Solutions Honeywell International Inc. Honeywell Limited-Honeywell Limitée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55422 Toronto, Ontario M1V 4Z9 customer.honeywell.com ® U.S. Registered Trademark © 2007 Honeywell International Inc. 69-1341EF—01 M.S. Rev. 07-07...
  • Page 9 Humidistat H8908A/B Déshumidistat H8908C/D NOTICE TECHNIQUE APPLICATION Les humidistats et les déshumidistats basse tension de la gamme H8908 assurent la régulation précise de l'humidification, la déshumidification et la ventilation dans toute la maison. Ils fonctionnent au moyen d'un interrupteur unipolaire unidirectionnel à rupture brusque, à...
  • Page 10 HUMIDISTAT H8908A/B DÉSHUMIDISTAT H8908C/D INSTALLATION SUR UNE GAINE MONTAGE À DISTANCE DANS UNE PIÈCE 1. Choisir l'emplacement sur la gaine. EMPLACEMENTS POSSIBLES 1. Choisir l'emplacement de montage dans la pièce. RETOUR RETOUR REMARQUE : Choisir un emplacement à l'abri des cou- D’AIR D’AIR rants d'air et de l'humidité...
  • Page 11 HUMIDISTAT H8908A/B DÉSHUMIDISTAT H8908C/D 4. Retirer la plaque de montage de l'humidistat. Dans le cas d'une installation sur une gaine, insérer la garniture d'étanchéité sur la plaque de montage. Voir la Fig. 8. REMARQUE : Utiliser la garniture seulement pour une installation sur une gaine.
  • Page 12 HUMIDISTAT H8908A/B DÉSHUMIDISTAT H8908C/D RACCORDEMENT bas de l'humidistat pour enclencher la charnière du bas. Un clic se fait entendre lorsque l'humidistat est bien en place. MISE EN GARDE Risque de blessure Peut causer des chocs électriques et des blessures. Débrancher toute source d'alimentation avant d'installer ou de réparer.
  • Page 13 HUMIDISTAT H8908A/B DÉSHUMIDISTAT H8908C/D H8908 H8908 INTERRUPTEUR À AILETTES FILS DU SOLÉNOÏDE DE L’EAU TRANSFORMATEUR TRANSFORMATEUR L1 (SOUS L1 (SOUS TENSION) TENSION) HUMIDIFICATEUR ALIMENTATION. FOURNIR, AU BESOIN, UN DISPOSITIF DE COUPURE ET UNE PROTECTION CONTRE LES SURCHARGES. RELAIS À CAPTEUR DE MF24730 CÂBLAGE 24 V c.a.
  • Page 14 HUMIDISTAT H8908A/B DÉSHUMIDISTAT H8908C/D THERMOSTAT VISIONPRO ® H8908D VENTILATEUR/DÉSHUMIDIFICATEUR BORNES H8908D Fresh Air Ventilation System Système de ventilation à air frais RELAIS DE CHAUFFAGE MF24732 OU BOBINE DE LA VANNE Fig. 19. Schéma de raccordement typique dans des applications de ventilation avec un HR150, HR200, ER150 et ER200 ou de déshumidification avec un BOBINE DU BOBINE DU...
  • Page 15 HUMIDISTAT H8908A/B DÉSHUMIDISTAT H8908C/D VÉRIFICATION FONCTIONNEMENT Tourner le cadran du H8908 jusqu'à la position Réglage du régulateur d'humidité « marche » pour vérifier le fonctionnement de l'installation. Voir la Fig. 20. Pour obtenir un niveau d'humidité optimal sans condensation sur les surfaces froides comme les Si l'installation est bien effectuée, un clic se fait entendre fenêtres, il faut régler le point de consigne de l'humidité...
  • Page 16 Honeywell International Inc. Honeywell Limited-Honeywell Limitée 1985 Douglas Drive North 35, Dynamic Drive Golden Valley, MN 55422 Toronto (Ontario) M1V 4Z9 customer.honeywell.com ® Marque de commerce déposée aux É.-U. © 2007 Honeywell International Inc. Tous droits réservés 69-1341EF—01 M.S. Rév. 07-07...

This manual is also suitable for:

H8908aH8908bH8908cH8908d

Table of Contents