Dell 2000FP Installation Instructions Manual
Logic board
Hide thumbs
Also See for 2000FP:
- Service manual (50 pages) ,
- Quick setup manual (4 pages) ,
- Quick setup manual (4 pages)
Quick Links
See also:
Service Manual
Norris Parts Repair Manual
1
Dell 2000FP Logic Board
Installation Instructions
Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
Related Manuals for Dell 2000FP
Summary of Contents for Dell 2000FP
- Page 1 Norris Parts Repair Manual Dell 2000FP Logic Board Installation Instructions Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited.
-
Page 2: Lcd Monitor
Norris Parts Repair Manual The Dell 2000FP was designed for a wide variety of users ranging from the home, small office, or corporate environment. It utilizes a 20.1-inch (51.0cm) Active Matrix TFT LCD that displays sharp and brilliant images of text and graphics with a maximum resolution up to 1600 x 1200 pixels. - Page 3 Norris Parts Repair Manual Disassembly Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 1: Remove the four (4) screws from the top of the base. Step 2: Remove the base. Step 3: Remove the four (4) screws from the back cover.
- Page 4 Norris Parts Repair Manual Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 4: Stick a flat screw driver between the back cover and the front bezel on the bottom of the LCD. Step 5: Remove the back cover from the bottom of the LCD.
- Page 5 Norris Parts Repair Manual Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 7: Rotate the LCD to the side to continue removing the back cover. Step 8: Rotate the LCD to the other side to continue removing the back cover.
- Page 6 Norris Parts Repair Manual Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 9: Remove the back cover. Step 10: Remove the two (2) screws from the inverter board’s metal cover. Step 11: Remove the inverter board’s metal cover.
- Page 7 Norris Parts Repair Manual Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 12: Remove the fifteen (15) screws from the logic board’s metal cover. Step 13: Remove the logic board’s metal cover.
- Page 8 Norris Parts Repair Manual Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 14: Unplug connector from the logic board. Step 15: Unplug the two (2) connectors from the logic board. Step 16: Unplug connector from the logic board.
- Page 9 Norris Parts Repair Manual Copyright©2006 – All Rights Reserved - Distribution or Duplication of this document is prohibited. Step 17: Unplug connector from the logic board. Step 18: Remove the seven (7) screws from the logic board.
- Page 10 Norris Parts Repair Manual Step 20 – Reassembly Inspect new part ensuring that any packing materials or tape are removed. Follow the directions in reverse to complete the installation of the replacement part. Make sure that all connectors are plugged in. Make sure that you replace all screws into their assemblies.