Sony CFD-E10 Operating Instructions

Precautions

On safety

On operation

• As the laser beam used in the CD

• If the player is brought directly

player section is harmful to the

from a cold to a warm location, or

eyes, do not attempt to disassemble

is placed in a very damp room,

the casing. Refer servicing to

moisture may condense on the

qualified personnel only.

lenses inside the CD player section.

• Should any solid object or liquid

Should this occur, the player will

fall into the player, unplug the

not operate properly. In this case,

player, and have it checked by

remove the CD and wait about an

qualified personnel before

hour for the moisture to evaporate.

operating it any further.

• Discs with non-standard shapes

If you have any questions or

(e.g., heart, square, star) cannot be

problems concerning your player,

played on this player. Attempting

please consult your nearest Sony

to do so may damage the player.

dealer.

Do not use such discs.

Notes on CDs

Cleaning the cabinet

• Before playing,

• Clean the cabinet, panel and

clean the CD

controls with a soft cloth slightly

with a cleaning

moistened with a mild detergent

cloth. Wipe the

solution. Do not use any type of

CD from the

abrasive pad, scouring powder, or

center out.

solvent, such as alcohol or benzine.

• Do not use solvents such as

benzine, thinner, commercially

On power sources

available cleaners or anti-static

• For AC

spray intended for vinyl LPs.

operation, use

• Do not expose the CD to direct

the supplied

sunlight or heat sources such as hot

AC power

air ducts, nor leave it in a car

Polarity of

adaptor; do not

the plug

parked in direct sunlight as there

use any other type.

can be a considerable rise in

• The player is not disconnected

temperature inside the car.

from the AC power source (mains)

• Do not stick paper or sticker on the

as long as it is connected to the

CD, nor scratch the surface of the

wall outlet, even if the player itself

CD.

has been turned off.

• After playing, store the CD in its

• Unplug the player from the wall

case.

outlet when it is not to be used for

If there is a scratch, dirt or

an extended period of time.

fingerprints on the CD, it may cause

• For battery operation, use four size

tracking error.

AA (R6) batteries.

• When the batteries are not to be

used, remove them to avoid

damage that can be caused by

battery leakage or corrosion.

• The nameplate indicating operating

voltage, power consumption, etc. is

located at the bottom.

On placement

• Do not leave the player in a

location near heat sources, or in a

place subject to direct sunlight,

excessive dust or mechanical

shock.

• Do not place the player on an

inclined or unstable place.

• Do not place anything within 10

mm of the side of the cabinet. The

ventilation holes must be

unobstructed for the player to

operate properly and prolong the

life of its components.

• If the player is left in a car parked

in the sun, be sure to choose a

location in the car where the player

will not be subjected to the direct

rays of the sun.

• Since a strong magnet is used for

the speakers, keep personal credit

cards using magnetic coding or

spring-wound watches away from

the player to prevent possible

damage from the magnet.

WARNING

To prevent fire or

Personal

shock hazard, do not

expose the player to

Audio

rain or moisture.

System

Operating Instructions

This symbol is intended

to alert the user to the

presence of uninsulated

“dangerous voltage”

within the product's

enclosure that may be of

sufficient magnitude to

constitute a risk of

electric shock to persons.

This symbol is intended

to alert the user to the

presence of important

CFD-E10

operating and

maintenance (servicing)

instructions in the

Sony Corporation ©2002

literature accompanying

Printed in China

the appliance.

3-234-994-11(1)

CD player section

General

System

Speaker

Full range: 5.7 cm dia., 2.7 Ω, cone

Compact disc digital audio system

type (2)

Laser diode properties

Outputs

Material: GaAlAs

Headphones jack (stereo minijack)

Wave length: 780 nm

For 8 - 32 ohms impedance

Emission duration: Continuous

headphones

Laser output: Less than 44.6 µW

Power output

(This output is the value measured at a

1 W + 1 W (at 2.7 Ω , 10 % harmonic

distance of about 200 mm from the

distortion in AC operation)

objective lens surface on the optical

pick-up block with 7 mm aperture.)

Power requirements

Spindle speed

DC IN 6 V accepts:

Supplied AC power adaptor for use

200 r/min (rpm) to 500 r/min (rpm)

with 120 V AC, 60 Hz

(CLV)

6 V DC, 4 size AA (R6) batteries

Number of channels

Power consumption

2

DC 11.5 W

Frequency response

Battery life

20 - 20,000 Hz +1/–2 dB

When playing a CD:

Wow and flutter

Sony R6P: approx. 2 hours

Below measurable limit

Sony alkaline LR6: approx 4 hours

Radio section

Dimensions

Approx. 315 × 131 × 70 mm (w/h/d)

Frequency range

× 5

× 2

FM: 87.5 - 108 MHz

5

1

7

(12

⁄

⁄

⁄

inches) (incl.

8

4

8

AM:530 - 1,710 kHz

projecting parts)

Antennas

Mass

FM: Telescopic antenna

Approx. 920 g (2 lb.) (incl. batteries)

AM: Built-in ferrite bar antenna

Supplied accessory

AC power adaptor (1)

Design and specifications are subject to

change without notice.

Optional accessories

Sony MDR headphone series

CAUTION

equipment off and on, the user is

encouraged to try to correct the

The use of optical instruments

interference by one or more of the

with this product will increase eye

following measures:

hazard.

— Reorient or relocate the

WARNING

receiving antenna.

Do not install the appliance in a

— Increase the separation

confined space, such as a

between the equipment and

bookcase or built-in cabinet.

receiver.

To prevent fire or shock hazard,

— Connect the equipment into an

do not place objects filled with

outlet on a circuit different

liquids, such as vases, on the

from that to which the receiver

appliance.

is connected.

Information

— Consult the dealer or an

experienced radio/TV

For customers in the USA

technician for help.

This equipment has been tested

You are cautioned that any

and found to comply with the

changes or modifications not

limits for a Class B digital device,

expressly approved in this manual

pursuant to Part 15 of the FCC

could void your authority to

Rules. These limits are designed

operate this equipment.

to provide reasonable protection

Owner's Record

against harmful interference in a

residential installation. This

The model number is located at

equipment generates, uses and can

the bottom and the serial number

radiate radio frequency energy

is located in the battery

and, if not installed and used in

compartment.

accordance with the instructions,

Record the serial number in the

may cause harmful interference to

space provided below. Refer to

radio communications. However,

these numbers whenever you call

there is no guarantee that

upon your Sony dealer regarding

interference will not occur in a

this product.

particular installation. If this

Model No. CFD-E10

equipment does cause harmful

Serial No. __________________

interference to radio or television

reception, which can be

determined by turning the

For customers in the USA

Please register this product on line at http://www.sony.com/

productregistration.

Proper registration will enable us to send you periodic mailings about

new products, services and other important announcements.

Registering your product will also allow us to contact you in the

unlikely event that the product needs adjustment or modification.

Thank you.