Mitsubishi Electric PAC-SH63AG-E Series Manual

Air Protect Guide

Photo

Dimensions

200

25

155

Hole

Hole

Hole

* Air Guide prevents reverse rotation of outdoor unit fan when it enters low speed rotation mode with fan controller being operated.

It is also used for protection of fan when strong winds, such as a typhoon, wind blowing through tall buildings, etc., directly strike the air outlet.

In addition, installation of this product is necessary when cooling opetation is to be performed in outdoor tempreture of -5℃ or lower (down to -15℃).

Note the followings when installing this guide:

1) Be sure not to use "upward discharge" in a place where snowing is possible. Snow may accumulate in the guard, which could damage the fan, etc.

2) Attaching this unit will decrease the performance (by 2-3%) and increase noise from outdoor unit (by approx. 1-2 dB).

3) Do not use "upward discharge" when there are any obstacles at the back and on both sides of outdoor unit (air is taken in from top of unit):

This could cause a short cycle.

4) To eliminate the influence of external wind, be sure to install the unit with its back facing to wall.

5) Do not install this unit in a place where wind directly blows to the back of the unit.

(for cooling at -15 )

Unit: mm (inch)

588

(Installation pitch of board B and outdoor unit)

559

CAUTION

* model change from PAC-SG57AG-E from Sep 2005

Descriptions

Enables operation even when the outside temperature is low.

Protect the unit from cold wind.

Applicable Models

PUZ-ZM60VHA type

■

PUZ-ZM71VHA type

■

[R32 type]

Specifications

Color (Munsell)

Surface treatment

Exterior

Material

Weight

Accessory name x Qty.

4-φ7hole

Outdoor unit installation side

PAC-SH63AG-E *

PUHZ-ZRP60HA2

■

PUHZ-ZRP71VHA2

■

1 piece required

PUHZ-SHW112VHA

■

PUHZ-SHW112YHA

■

PUHZ-SHW140YHA

■

2 pieces required

[R410A type]

Ivory (3.0Y 7.8/1.1)

Acrylic resin coating

Alloy hot-dip zinc-coated carbon steel

sheet

3.3kg

Washer faced screw (M5x15) x 4