KitchenAid KSMMGA Food Grinder Attachment Manual

KitchenAid KSMMGA Food Grinder Attachment Manual

Also See for KSMMGA:
KitchenAid KSMMGA Food Grinder Attachment Manual

PARTS AND FEATURES

PARTS AND FEATURES

METAL FOOD GRINDER ATTACHMENT SAFETY

Your safety and the safety of others are very important.

We have provided many important safety messages in this manual and on your appliance Always read and obey all safety messages.
warning This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.

All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean:


You can be killed or seriously injured if you don't immediately follow instructions.


You can be killed or seriously injured if you don't follow instructions.

All safety messages will te you wnat the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.

State of California Proposition 65 Warnings:

This product contains one or more chemicals known to the State of
California to cause cancer.


This product contains one or more chemicals known to the
State of California to cause birth defects or other reproductive harm.

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be followed, including the following:

SAVE THESE INSTRUCTIONS
This product is designed for household use only.

USING THE METAL FOOD GRINDER ATTACHMENT

GUIDE TO GRINDING
warning NOTE: None of the parts and accessories of this KitchenAid® Metal Food Grinder attachment

(model KSMMGA) are compatible with the parts and accessories of the KitchenAid® Food Grinder attachment (models FGA, SSA, FT, FVSP, FVSFGA, KSMFPPA, KSMGSSA) and vice versa.

USE THESE PARTS WITH THESE PARTS SUGGESTED USES SPEED
Fine grinding plate (3 mm) Blade Cooked meats for spreads, hard cheeses (e.g. Parmesan), bread crumbs 4
Medium grinding plate (4.5 mm) Blade Raw or cooked meats, meats for sausages 4
Coarse grinding plate (8 mm) Blade Raw meats for burgers and chili, vegetables for salsas and sauces 4
Small sausage stuffer tube (9.5 mm) Sausage stuffer plate Breakfast sausage, smaller sausages 4
Large sausage stuffer tube (19 mm) Sausage stuffer plate Bratwurst, larger sausages 4

ASSEMBLING THE METAL FOOD GRINDER ATTACHMENT

Wash all parts with warm, soapy water and dry thoroughly before use.

  1. Insert the grind screw into the main housing. Then, place the blade over the end of the grind screw. The blade should fit entirely inside the housing. If it doesn't, pull it off, turn it over, and place it again.
    ASSEMBLING THE METAL FOOD - Step 1
  2. Place grinding plate over the blade, matching the notch of the plate with the tab on the bottom of the main housing.
    ASSEMBLING THE METAL FOOD - Step 2
  3. Place the collar on the main housing, turning clockwise by hand until secured but not tightened.
    ASSEMBLING THE METAL FOOD - Step 3

ATTACHING THE METAL FOOD GRINDER ATTACHMENT TO THE STAND MIXER

  1. Turn the Stand Mixer off and unplug.
    STAND MIXER - Step 1
  2. For Stand Mixers with a hinged attachment hub cover: Flip up to open.
    For Stand Mixers with a removable attachment hub cover: Turn the attachment knob counterclockwise to remove attachment hub cover.
    STAND MIXER - Step 2
  3. Insert the attachment shaft housing into the attachment hub, making certain the power shaft fits into the square hub socket. If necessary, rotate the attachment back and forth. The pin on the attachment housing will fit into the notch of the hub rim when in the proper position.
    STAND MIXER - Step 3
  4. Tighten the Stand Mixer attachment hub knob clockwise until the attachment is completely secured to the Stand Mixer.
    STAND MIXER - Step 4

GRINDING WITH THE METAL FOOD GRINDER ATTACHMENT

  1. Cut food into small strips or pieces sized to fit into the feed tube.
    Cut food into small strips

Rotating Blade Hazard

Always use food pusher.
Keep fingers out of openings.
Keep away from children.
Failure to do so can result in amputation or cuts.

  1. Turn the Stand Mixer to Speed 4 and feed food into the feed tube using the food pusher.
    Turn the Stand Mixer to Speed 4 and feed food

ASSEMBLING THE SAUSAGE STUFFER

  1. Insert the grind screw into the main housing. Then insert the sausage stuffer plate over the end of the grind screw, matching the notch of the plate with the tab on the bottom of the main housing.
    ASSEMBLING THE SAUSAGE STUFFER - Step 1
  2. Insert the desired sausage stuffer tube (large or small) through the collar. Then, place the collar and tube assembly on the main housing, turning the ring by hand until secured but not tightened.
    ASSEMBLING THE SAUSAGE STUFFER - Step 2

USING THE SAUSAGE STUFFER

  1. Feed meat into the Metal Food Grinder attachment before adding the sausage stuffer tube. This will eliminate air pockets.
    USING THE SAUSAGE STUFFER - Step 1
  2. Lubricate the sausage stuffer tube and slide one casing over the tube, leaving about four inches to tie off the end.
    USING THE SAUSAGE STUFFER - Step 2
  3. Turn the Stand Mixer on to Speed 4 and slowly push the meat through the grinder. Hold the casing firmly as it fills. If air bubbles are created during the fill process, use a pin or needle to pop the bubble.
    USING THE SAUSAGE STUFFER - Step 3
  4. Run meat through until 4-6 inches of casing is left unfilled. Turn off the Stand Mixer and tie the remaining end of the casing, or use a tie string.
    USING THE SAUSAGE STUFFER - Step 4

warning NOTE: For segmented-type sausage (e.g., bratwurst), twist casing ends in alternating directions at desired sausage link length.

TIPS FOR GREAT RESULTS

HELPFUL HINTS
For best results, grind meat that is very cold or partially frozen. The grinder parts can be pre-chilled in the refrigerator or freezer before use to maintain a cold grinding temperature.

For more tender results, some meats can be ground twice. However, fatty meats should be ground only once.

To grind bread for crumbs, be sure that bread is either oven-dried thoroughly to remove all moisture, or not dried at all. Partially dried bread may jam the Metal Food Grinder attachment.

warning NOTE: Very hard, dense foods such as completely dried homemade bread should not be ground in the Metal Food Grinder attachment. Homemade bread should be ground fresh and then oven- or air-dried.

If using natural casings, it is recommended to first soak them in cold water for 30 minutes to remove excess salt, then rinse several times by running cold water through the entire length of the casing. For best results for sausage, refer also to the instructions that came with the casings.

CARE AND CLEANING

CLEANING THE METAL FOOD GRINDER ATTACHMENT AND ACCESSORIES

  1. Use the cleaning brush to clean the main housing and other accessories, including the grinding plates.
    Use the cleaning brush to clean
  2. The following parts are dishwasher-safe, top rack only: sausage stuffer plate, sausage stuffer tubes, cleaning brush, and food pusher.
    The following parts are dishwasher-safe, top rack only
  3. The following parts should be hand-washed only, using warm, soapy water and drying thoroughly: main housing, grind screw, collar, tray, grinding plates, and blade.
    The following parts should be hand-washed only

FOR DETAILED INFORMATION ON USING THE METAL FOOD GRINDER ATTACHMENT
Visit kitchenaid.com/quickstart for additional instructions with videos, inspiring recipes, and tips on how to use your Food Grinder attachment.

WARRANTY AND SERVICE

KITCHENAID METAL FOOD GRINDER ATTACHMENT WARRANTY FOR THE 50 UNITED STATES, THE DISTRICT OF COLUMBIA, PUERTO RICO, AND CANADA

This warranty extends to the purchaser and any succeeding owner for Metal Food Grinder attachments operated in the 50 United States, the District of Columbia, Puerto Rico, and Canada.

Length of Warranty: One Year Full Warranty from date of purchase.
KitchenAid Will Pay for Your Choice of:
Hassle-Free Replacement of your Metal Food Grinder attachment. See the next page for details on how to arrange for service, or call the Customer eXperience Center toll-free at
1-800-541-6390.
OR
The replacement parts and repair labor costs to correct defects in materials and workmanship. Service must be provided by an Authorized KitchenAid Service Center.
KitchenAid Will Not Pay for:

DISCLAIMER OF IMPLIED WARRANTIES; LIMITATION OF REMEDIES
IMPLIED WARRANTIES, INCLUDING TO THE EXTENT APPLICABLE WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE EXCLUDED TO THE EXTENT LEGALLY PERMISSIBLE. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW ARE LIMITED TO ONE YEAR, OR THE SHORTEST PERIOD ALLOWED BY LAW. SOME STATES AND PROVINCES DO NOT ALLOW LIMITATIONS OR EXCLUSIONS ON HOW LONG AN IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS LASTS, SO THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU.

IF THIS PRODUCT FAILS TO WORK AS WARRANTED, CUSTOMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE REPAIR OR REPLACEMENT ACCORDING TO THE TERMS OF THIS LIMITED WARRANTY. KITCHENAID AND KITCHENAID CANADA DO NOT ASSUME ANY RESPONSIBILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. This warranty gives you specific legal rights and you may also have other rights which vary from state to state or province to province.

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Table of Contents