Table of Contents
DRIVE SHAFT BOOT INSPECTION
Inspect the front and rear drive shaft boots
damage, tears, wear or leaking grease. If the boots
exhibit any of these symptoms, they should be replaced.
Check to see the boot clamps
See "Drive Shaft CV Joint / Boot Replacement" page
7.20 for drive shaft boot replacement.
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
q
for
w
are properly positioned.
WHEEL AND HUB TORQUE TABLE
ITEM
SPECIFICATION
Wheel Nuts
30 ft-lbs + 90° (41 Nm)
(Aluminum Wheels)
110 ft-lbs (149Nm)
Front
Hub Retaining
Nuts
110 ft-lbs (149Nm)
Rear
NOTE
Do not lubricate the stud or the lug nut.
WHEEL REMOVAL
1. Position the vehicle on a level surface.
2. Place the transmission in PARK and stop the engine.
3. Loosen the wheel nuts slightly. If wheel hub removal
is required, remove the wheel cap, cotter pin and
loosen the hub nut slightly.
4. Elevate the appropriate side of the vehicle by placing
a suitable stand under the frame.
5. Remove the wheel nuts and remove the wheel.
MAINTENANCE
2
2.39
Chapters
Table of Contents
Troubleshooting
